DB1065 Datasheet, PDF (10/23 Pages) CML Microcircuits – CTCSS Encoder / Decoder Development Kit

CTCSS tone
generator
Noise
generator
Audio signal
generator
CTCSS tone @
30mvrms
.1uF
Noise generator @
75mvrms, Band limited
6khz gaussian
100K
.1uF
1khz sine wave @
300mvrms
100K
+Vdd
.1uF ^100K
100K
.1uF
100K
+Vdd
-
+
100K _GND
To RXIN and
SINAD meter
Audio Opamp
741 or similar
GND
Figure 2: Composite test signal circuit diagram
Using the circuit above and setting the signal generators to the levels shown in the diagram
simulates a CTCSS signal in a worst case condition. The performance of the DB1065 can be
measured with a SINAD meter connected to RXIN while each signal generator is varied to
simulate different signaling conditions.
4.5 Performance at other operating voltages
The DB1065’s performance may be evaluated at supply voltages other than the +5VDC supplied
from the on board regulator.
a. Turn power supply off.
b. Disconnect the power supply’s connection to J1 the B+ connection on the DB1065.
c. Set the power supply for an output of +5VDC.
d. Turn power supply off and connect it to the +5V J12 of the DB1065.
e. Turn on the power supply.
As an example, a DB1065 was configured to detect a 67Hz CTCSS tone using the following
configuration shown in Figure 3.
20480150.001 MX-COM
1996
Page 10