CPC5601 Datasheet, PDF (1/14 Pages) Clare, Inc. – Auxiliary Programmable Driver IC

CPC5601 LITELINK™ Family
Auxiliary Programmable Driver IC
Features
• Meets PC Card (PCMCIA) height requirements
• Zero standby current
• PCB real estate and cost savings
• Can be used with LITELINK II and LITELINK III parts
Compliance
The supplied application circuits comply with the
requirements of TIA/EIA/IS-968 (FCC part 68),
UL1950, UL60950, EN60950, IEC60950, EN55022B,
CISPR22B, EN55024, and TBR-21.
Ordering Information
Part Number Description
CPC5601D 16-pin SOIC, .300 inch wide package
Figure 1. CPC5601 Block Diagram
RING ¹
GND ²
INPUT ³
NC ⁶
Shift
Register
Drivers
16 _LED-
15
LED+
14
V_DDLINE
13 _B1
12 _B2
11 _B3
10
9
B4
B5
8 _B6
7 _-BR
Description
The CPC5601 is a serially-programmed driver IC for
use with Clare, Inc. LITELINK Silicon Data Access
Arrangement (DAA) ICs. The CPC5601 allows host-
equipment control of DAA characteristics for world-
wide DAA implementations, avoiding multiple imple-
mentations with discrete component changes or “stuff”
options. The small, low-profile package makes the
CPC5601 ideal for 56K PC Card (PCMCIA) modems,
PC motherboards, and soft-modems.
The CPC5601 uses opto-electronics to maintain the
isolation barrier required in the data access arrange-
ment for connection of host devices to the public
switched telephone network (PSTN).
The one-bit serial input of the CPC5601 recovers
clocking information from the input signal to set bits in
the shift register. The shift register outputs connect to
open-drain FET latches that are used to switch in dif-
ferent external components to set V/I slope, DC termi-
nation current limit, gain, and AC termination value in
LITELINK DAA implementations.The CPC5601 does
not need a clock signal for shift register operation, but
relies on internal timing instead.
The CPC5601 also includes an opto-coupler for ring
detection applications where the AC coupled ring
detector of the LITELINK DAA is not used.
DS-CPC5601-R3.0
www.clare.com
1