CS4362A_09 Datasheet, PDF (6/50 Pages) Cirrus Logic – 114 dB, 192 kHz 6-Channel D/A Converter

1. PIN DESCRIPTION
DSDA2
DSDB1
DSDA1
VD
GND
MCLK
LRCK(DSD_EN)
SDIN1
SCLK
TST
SDIN2
TST
48 47 46 45 44 43 42 41 40 39 38 37
1
36
2
35
3
34
4
33
5
32
6
CS4362A
31
7
30
8
29
9
28
10
27
11
26
12
25
13 14 15 16 17 18 19 20 21 22 23 24
AOUTA2-
AOUTA2+
AOUTB2+
AOUTB2-
VA
GND
AOUTA3-
AOUTA3+
AOUTB3+
AOUTB3-
MUTEC2
MUTEC3
CS4362A
Pin Name
VD
GND
MCLK
LRCK
SDIN1
SDIN2
SDIN3
SCLK
TST
RST
VA
VLS
VLC
#
Pin Description
4
Digital Power (Input) - Positive power supply for the digital section. Refer to the Recom-
mended Operating Conditions for appropriate voltages.
5,31 Ground (Input) - Ground reference. Should be connected to analog ground.
6
Master Clock (Input) - Clock source for the delta-sigma modulator and digital filters. Table 1
illustrates several standard audio sample rates and the required master clock frequencies.
7
Left Right Clock (Input) - Determines which channel, Left or Right, is currently active on the
serial audio data line. The frequency of the left/right clock must be at the audio sample rate, Fs.
8
11 Serial Data Input (Input) - Input for two’s complement serial audio data.
13
9 Serial Clock (Input) - Serial clocks for the serial audio interface.
10,12
14,44 Test - These pins need to be tied to analog ground.
45
19
Reset (Input) - The device enters a low power mode and all internal registers are reset to their
default settings when low.
32
Analog Power (Input) - Positive power supply for the analog section. Refer to the Recom-
mended Operating Conditions for appropriate voltages.
43
Serial Audio Interface Power (Input) - Determines the required signal level for the serial audio
interface. Refer to the Recommended Operating Conditions for appropriate voltages.
Control Port Power (Input) - Determines the required signal level for the control port and hard-
18 ware mode configuration pins. Refer to the Recommended Operating Conditions for appropri-
ate voltages.
6
DS617F2