CS4365_08 Datasheet, PDF (22/52 Pages) Cirrus Logic – 114 dB, 192 kHz 6-Channel D/A Converter

CS4365
4.2 Mode Select
In Hardware Mode, operation is determined by the Mode Select pins. The states of these pins are continu-
ally scanned for any changes; however, the mode should only be changed while the device is in reset
(RST pin low) to ensure proper switching from one mode to another. These pins require connection to sup-
ply or ground as outlined in Figure 7. For M0, M1, and M2, supply is VLC. For M3 and M4, supply is VLS.
Tables 4 - 6 show the decode of these pins.
In Software Mode, the operational mode and data format are set in the FM and DIF registers. See “PCM
Control (address 03h)” on page 35.
M1
(DIF1)
0
0
1
1
M0
(DIF0)
DESCRIPTION
FORMAT
0
Left-Justified, up to 24-bit data
0
1
I²S, up to 24-bit data
1
0
Right-Justified, 16-bit Data
2
1
Right-Justified, 24-bit Data
3
Table 4. PCM Digital Interface Format, Hardware Mode Options
FIGURE
8
9
10
11
M4
M3
M2
(DEM)
DESCRIPTION
0
0
0
Single-Speed without De-Emphasis (4 to 50 kHz sample rates)
0
0
1
Single-Speed with 44.1 kHz De-Emphasis; see Figure 16
0
1
0
Double-Speed (50 to 100 kHz sample rates)
0
1
1
Quad-Speed (100 to 200 kHz sample rates)
1
0
0
Auto Speed-Mode Detect (32 kHz to 200 kHz sample rates)
1
0
1
Auto Speed-Mode Detect with 44.1 kHz De-Emphasis; see Figure 16
1
1
X
DSD Processor Mode (see Table 6 for details)
Table 5. Mode Selection, Hardware Mode Options
M2
M1
M0
DESCRIPTION
0
0
0
64x oversampled DSD data with a 4x MCLK to DSD data rate
0
0
1
64x oversampled DSD data with a 6x MCLK to DSD data rate
0
1
0
64x oversampled DSD data with a 8x MCLK to DSD data rate
0
1
1
64x oversampled DSD data with a 12x MCLK to DSD data rate
1
0
0
128x oversampled DSD data with a 2x MCLK to DSD data rate
1
0
1
128x oversampled DSD data with a 3x MCLK to DSD data rate
1
1
0
128x oversampled DSD data with a 4x MCLK to DSD data rate
1
1
1
128x oversampled DSD data with a 6x MCLK to DSD data rate
Table 6. Direct Stream Digital (DSD), Hardware Mode Options
22
DS670F2