WM1824 Datasheet, PDF (20/23 Pages) Wolfson Microelectronics plc – 24-bit 192kHz Stereo DAC with 2Vrms Ground Referenced Line Output

WM1824
RECOMMENDED ANALOGUE LOW PASS FILTER
LINEVOUT
560Ω
2.7nF
Production Data
Figure 15 Recommended Analogue Low Pass Filter (one channel shown)
An external single-pole RC filter is recommended if the device is driving a wideband amplifier.
Other filter architectures may provide equally good results.
The filter shown in Figure 15 has a -3dB cut-off at 105.26kHz and a droop of 0.15dB at
20kHz. The typical output from the WM1824 is 2.1Vrms – when a 10kΩ load is placed at the
output of this recommended filter the amplitude across this load is 1.99Vrms.
RELEVANT APPLICATION NOTES
The following application notes may provide additional guidance for use of the WM1824.
DEVICE PERFORMANCE:
WAN0129 – Decoupling and Layout Methodology for Wolfson DACs, ADCs and CODECs
WAN0144 – Using Wolfson Audio DACs and CODECs with Noisy Supplies
GENERAL:
WAN0108 – Moisture Sensitivity Classification and Plastic IC Packaging
WAN0109 – ESD Damage in Integrated Circuits: Causes and Prevention
WAN0158 – Lead-Free Solder Profiles for Lead-Free Components
WAN0161 – Electronic End-Product Design for ESD
If you require more information or require technical support, please contact the nearest
Wolfson Microelectronics regional office:
http://www.wolfsonmicro.com/contact
or one of our global distributors:
http://www.wolfsonmicro.com/distribution
w
PD, Rev 4.1, December 2011
20