WM1824 Datasheet, PDF (10/23 Pages) Wolfson Microelectronics plc – 24-bit 192kHz Stereo DAC with 2Vrms Ground Referenced Line Output

WM1824
POWER ON RESET CIRCUIT
Production Data
Figure 3 Internal Power on Reset Circuit Schematic
The WM1824 includes an internal Power-On-Reset circuit, as shown in Figure 3, which is
used to reset the DAC digital logic into a default state after power up. The POR circuit is
powered by AVDD and has as its inputs VMID and LINEVDD. It asserts POR low if VMID or
LINEVDD are below a minimum threshold.
Figure 4 Typical Power Timing Requirements
Figure 4 shows a typical power-up sequence where LINEVDD comes up with AVDD. When
AVDD goes above the minimum threshold, V_pora, there is enough voltage for the circuit to
guarantee POR is asserted low and the chip is held in reset. In this condition, all writes to the
control interface are ignored. After VMID rises to V_{pord_hi} and AVDD rises to V_{pora_hi,} POR is
released high and access to the control interface and audio interface may take place. This
assumes that DBVDD is at a level within the recommended operating conditions.
w
PD, Rev 4.1, December 2011
10