|
CS2200-OTP_09 Datasheet, PDF (18/24 Pages) Cirrus Logic – Fractional-N Frequency Synthesizer | |||
|
◁ |
6.1.2
CS2200-OTP
Auxiliary Output Source Selection (AuxOutSrc[1:0])
Selects the source of the AUX_OUT signal.
AuxOutSrc[1:0]
00
01
10
11
Application:
Auxiliary Output Source
RefClk.
Reserved.
CLK_OUT.
PLL Lock Status Indicator.
âAuxiliary Outputâ on page 14
Note: When set to 11, the AuxLockCfg global parameter sets the polarity and driver type (âAUX PLL
Lock Output Configuration (AuxLockCfg)â on page 18).
6.2 Ratio 0 - 3
The four 32-bit User Defined Ratios are stored in the CS2200âs one time programmable memory. See âOut-
put to Input Frequency Ratio Configurationâ on page 11 and âCalculating the User Defined Ratioâ on
page 20 for more details.
6.3 Global Configuration Parameters
6.3.1
AUX PLL Lock Output Configuration (AuxLockCfg)
When the AUX_OUT pin is configured as a lock indicator (AuxOutSrc[1:0] modal parameter = â11â), this
global parameter configures the AUX_OUT driver to either push-pull or open drain. It also determines the
polarity of the lock signal. If AUX_OUT is configured as a clock output, the state of this parameter is dis-
regarded.
AuxLockCfg
0
1
Application:
AUX_OUT Driver Configuration
Push-Pull, Active High (output âhighâ for unlocked condition, âlowâ for locked condition).
Open Drain, Active Low (output âlowâ for unlocked condition, high-Z for locked condition).
âAuxiliary Outputâ on page 14
Note: AUX_OUT is an unlock indicator, signalling an error condition when the PLL is unlocked. There-
fore, the pin polarity is defined relative to the unlock condition.
6.3.2
Reference Clock Input Divider (RefClkDiv[1:0])
Selects the input divider for the timing reference clock.
RefClkDiv[1:0]
00
01
10
11
Application:
Reference Clock Input Divider
REF_CLK Frequency Range
÷ 4.
32 MHz to 56 MHz (50 MHz with XTI)
÷ 2.
16 MHz to 28 MHz
÷ 1.
8 MHz to 14 MHz
Reserved.
âInternal Timing Reference Clock Dividerâ on page 9
18
DS842F1
|
▷ |