English
Language : 

CAT25020 Datasheet, PDF (6/18 Pages) Catalyst Semiconductor – 1K/2K/4K SPI Serial CMOS EEPROM
CAT25010, CAT25020, CAT25040
STATUS REGISTER
The Status Register indicates the status of the device.
The RDY (Ready) bit indicates whether the CAT25010/
20/40 is busy with a write operation. When set to 1 a
write cycle is in progress and when set to 0 the device
indicates it is ready. This bit is read only.
The WEL (Write Enable) bit indicates the status of the
write enable latch. When set to 1, the device is in a Write
Enable state and when set to 0 the device is in a Write
Disable state. The WEL bit can only be set by the WREN
instruction and can be reset by the WRDI instruction.
The BP0 and BP1 (Block Protect) bits indicate which
blocks are currently protected. These bits are set by the
user issuing the WRSR instruction. The user is allowed
to protect quarter of the memory, half of the memory or
the entire memory by setting these bits. Once protected,
the user may only read from the protected portion of the
array. These bits are non-volatile.
DEVICE OPERATION
Write Enable and Disable
The CAT25010/20/40 contains a write enable latch. This
latch must be set before any write operation. The device
powers up in a write disable state when Vcc is applied.
WREN instruction will enable writes (set the latch) to the
device. If WP pin is held low, the write enable latch is
reset to the write disabe state, regardless of the WREN
Instruction. WRDI instruction will disable writes (reset
the latch) to the device. Disabling writes will protect the
device against inadvertent writes.
READ Sequence
The part is selected by pulling CS low. The 8-bit read
instruction is transmitted to the CAT25010/20/40, followed
by the 8-bit address for CAT25010/20/40 (for the 25040,
bit 3 of the read data instruction contains address A8).
After the correct read instruction and address are sent,
the data stored in the memory at the selected address is
shifted out on the SO pin. The data stored in the memory
at the next address can be read sequentially by continuing
Figure 2. WREN Instruction Timing
CS
SCK
SI
SO
Note: Dashed Line = mode (1, 1) – – – – –
0 0 0 0 0 1 10
HIGH IMPEDANCE
Figure 3. WRDI Instruction Timing
CS
SCK
SI
0 0 0 0 0 1 00
SO
Note: Dashed Line = mode (1, 1) – – – – –
HIGH IMPEDANCE
Doc. No. 1006, Rev. S
6
© 2006 by Catalyst Semiconductor, Inc.
Characteristics subject to change without notice