S016-1220120-FB Datasheet, PDF (6/9 Pages) C&D Technologies – DC/DC Converter 12V Input, 1.2 - 5.0V Adjustable Output, 16A or 45W

DC Voltage Regulation
DC/D^DC^C/DC^Co^Cn^ovⁿe^vr^et^re^ter^r
Programmable, Single Output, 1.1V - 1.85Vout @ 60A
12V Input, 1.2 - 5.0V Adjustable Output, 16A or 45W
The DC output voltages will remain within the regulation ranges shown in the following table
when measured at the load end of the connector. Connect Set Resistor per table below from
Trim (Pin4) to Ground (Pin7). Regulation range includes output voltage Set Point, Line
Regulation & Load Regulation over the temperature range.
Output Level
+5V
+3.3V
+2.5V
+1.8V
1.5V
1.25V
1.2V
Minimum
-3%
-3%
-3%
-3%
-3%
-3%
-3%
Maximum
+3%
+3%
+3%
+3%
+3%
+3%
+3%
The above regulations should be for all operating conditions.
Set Resistor (1%tol)
309Ω
562 Ω
909 Ω
1.96kΩ
3.92kΩ
23.7kΩ
Open ( no resistor)
( ^{0.992 0.992}
V_o:=
+
5.62k Rset
1.18k + 0.992
Input Ripple Current
6.0
5.0
Approximate ripple current
ratings required for input
4.0
bulk capacitor.
3.0
2.0
1.0
Vo=2.5
Vo=1.5
0
2 4 6 8 10 12 14 16
Output Current (A)
DC Input Reflected Ripple
Maximum reflected current ripple will not exceed 150mA (pk-pk) 5Hz to 20MHz per test setup
indicated below.
0.5µH
Ltest = 500nH Cs = 270µF Esr < 0.1 ohm at 100kHz 20°C
C1 = 270µF Esr < 0.02 ohm at 100kHz 20°C , C2 = 2µF ceramic
Tektronix current Probe P/N TCP202
Filter components should be mounted close to the module.
1150 Eglinton Avenue East
Toronto, Ontario M3C 1H7
1-866-740-1232
S016_084-S016-00_RevG_Jan12-2005.fm
www.cdtechno-cps.com
4607 S.E. International Way
Milwaukie, Oregon 97222
1-971-206-2800
6 of 9