English
Language : 

PACS1284-06 Datasheet, PDF (3/5 Pages) California Micro Devices Corp – P/ACTIVE IEEE 1284 ECP/EPP TERMINATION NETWORK
CALIFORNIA MICRO DEVICES
PACS1284-06
Application Information
The IEEE 1284 specification requires both termination and EMI filtering on a total of 17 signal lines. Control and
Status lines (8 in total) only require a pull-up resistor and a filter capacitor. The Data lines and Strobe also require a
series termination resistor in addition to the pull resistors and filter capacitors. See Table 1 and Schematic Diagram.
SIGNAL NAME
Data1 - Data8
Strobe
Init
AutoFeedXT
Selectin
Ack
Busy
Paper Empty
Select
Fault
SERIES TERMINATION
Yes
Yes
Not Required
Not Required
Not Required
Not Required
Not Required
Not Required
Not Required
Not Required
IEEE 1284 defines three interface connectors:
- 1284 A is a 25-pin DB series connector which is the defacto PC standard for the host connection.
- 1284 B is a 36-pin, 0.085 inch centerline connector used on the peripheral device.
- 1284 C is a new 36-pin, 0.050 inch centerline connector which can be used for both host and peripheral.
Figure 1 shows a possible hook-up between the 1284-A connector on a PC motherboard and the PACS1284-06,
illustrating how the pin configuration of the PACS1284-06 allows for easy interconnects between the two. The dotted I/
O signals of the PACS1284-06 will typically be connected to a Super I/O chip on the motherboard.
Figure 2 shows a possible hook-up between the 1284-B connector on a peripheral and the PACS1284-06.
Figure 3 shows a possible hook-up between the 1284-C connector and the PACS1284-06.
1284-A Connector
Host
14
25
1
13
1284-B Connector
Peripheral
19
1
SUPER 1284
1
= FLOW
THROUGH
SIGNALS
SUPER 1284
1
1284-C Connector
Host/Peripheral
36
20
19
2
18
1
36
18
= GND
= VCC
SUPER 1284
1
Figure 1
Figure 2
Figure 3
Sample Hook-ups of IEEE 1284 Connectors and PACS1284-06.
(connector and PACS1284-06 not drawn to scale)
© 2000 California Micro Devices Corp. All rights reserved.
8/25/2000 215 Topaz Street, Milpitas, California 95035
Tel: (408) 263-3214
Fax: (408) 263-7846
www.calmicro.com
3