CM1452 Datasheet, PDF (3/6 Pages) California Micro Devices Corp – LCD & Camera EMI Filter Array with ESD Protection

Part Ordering Information
Pins
10
15
20
Package
CSP
CSP
CSP
Lead-free Finish
CM1452-04CP
CM1452-06CP
CM1452-08CP
PRELIMINARY
Electrical Specifications
Specifications: (At 25 C unless specified otherwise)
Channel Inductance
Total Channel Capacitance at 2.5Vdc; 1MHz, 30mVac
Capacitance C1 at 2.5V dc; 1MHz, 30mV ac
Cut-off Frequency, Z_SOURCE = 50 , Z_LOAD = 50
Roll-off Frequency at -6dB Attenuation, Z_SOURCE = 50 ,
Z_LOAD = 50
Stand-off Voltage, I = 10mA
Diode Leakage at 3.3V reverse bias voltage
Signal Clamp Voltage:
Positive Clamp, 10mA
Negative Clamp, -10mA
In-system ESD withstand voltage*:
Human Body Model (MIL-STD-883, method 3015)
IEC 61000-4-2, contact discharge method
Dynamic Resistance
Positive
Negative
Temperature Range:
Operating
Storage
Current per Inductor:
DC Package Power Rating:
Min.
32
16
Typ.
17
40
20
148
330
Max.
48
24
Unit
nH
pF
pF
MHz
MHz
5.5
0.1
V
1.0
µA
5.6
6.8
9.0
V
-1.5 -0.8
-0.4
V
30
kV
15
kV
2.3
0.9
-40
85
C
-65
150
30
mA
0.5
W
* ESD applied to input/output pins with respect to GND, one at a time. Clamping voltage is measured at the opposite side of the
EMI filter to the ESD pin (i.e. if ESD is applied to pin A1 then clamping voltage is measured at pin C1). Unused pins are left
open. These parameters are guaranteed by design.
© 2005 California Micro Devices Corp. All rights reserved.
6/23/05 430 N. McCarthy Blvd., Milpitas, California 95035 Tel: [phone] Fax: [phone]
www.calmicro.com
3