CM1425 Datasheet, PDF (3/7 Pages) California Micro Devices Corp – 4 Channel EMI Filter Array with ESD Protection

Specifications
PARAMETER
Storage Temperature Range
Power Rating per Resistor
Package Power Rating
PRELIMINARY
CM1425
ABSOLUTE MAXIMUM RATINGS
RATING
-65 to +150
100
300
UNITS
°C
mW
mW
PARAMETER
Operating Temperature Range
STANDARD OPERATING CONDITIONS
RATING
-40 to +85
UNITS
°C
ELECTRICAL OPERATING CHARACTERISTICS¹
SYMBOL PARAMETER
CONDITIONS
MIN
R
Resistance
80
C
Capacitance
At 2.5V DC, 1MHz, 30mV AC 16
V_DIODE Diode Standoff Voltage
I_DIODE = 10µA
5.5
I_LEAK Diode Leakage Current (reverse bias)
V_DIODE = 3.3V
V_SIG
Signal Voltage
Positive Clamp
Negative Clamp
I_LOAD = 10mA
5.6
I_LOAD = -10mA
-1.5
V_ESD In-system ESD Withstand Voltage
Notes 2,4 and 5
a) Human Body Model, MIL-STD-883,
±30
Method 3015
b) Contact Discharge per IEC 61000-4-
±15
2 Level 4
V_CL Clamping Voltage during ESD Discharge Notes 2,3,4 and 5
MIL-STD-883 (Method 3015), 8kV
Positive Transients
Negative Transients
f_C
Cut-off Frequency
Z_SOURCE=50Ω, Z_LOAD=50Ω
R = 100Ω, C = 20pF
TYP MAX UNITS
100
120
Ω
20
24
pF
V
100
nA
6.8
9.0
V
-0.8
-0.4
V
kV
kV
+12
V
-7
V
86
MHz
Note 1: T_A=25°C unless otherwise specified.
Note 2: ESD applied to input and output pins with respect to GND, one at a time.
Note 3: Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin. For example, if ESD is applied to Pin A1,
then clamping voltage is measured at Pin C1.
Note 4: Unused pins are left open
Note 5: These parameters are guaranteed by design and characterization.
© 2004 California Micro Devices Corp. All rights reserved.
04/21/04 430 N. McCarthy Blvd., Milpitas, CA 95035-5112
▲ Tel: [phone] ▲ Fax: [phone] ▲ www.calmicro.com
3