CM1406 Datasheet, PDF (3/7 Pages) California Micro Devices Corp – 4 Channel EMI Filter Array with ESD Protection

Specifications
PARAMETER
Storage Temperature Range
DC Power per Resistor
DC Package Power Rating
CM1406
ABSOLUTE MAXIMUM RATINGS
RATING
-65 to +150
100
300
UNITS
°C
mW
mW
PARAMETER
Operating Temperature Range
STANDARD OPERATING CONDITIONS
RATING
-40 to +85
UNITS
°C
ELECTRICAL OPERATING CHARACTERISTICS ^{(SEE NOTE 1)}
SYMBOL PARAMETER
CONDITIONS
MIN TYP MAX UNITS
R
Resistance
160
200
240
Ω
C
Capacitance
At 2.5V DC, 1MHz, 30mV
12
15
18
pF
AC
V_DIODE Diode Standoff Voltage
I_DIODE = 10µA
5.5
V
I_LEAK Diode Leakage Current (reverse bias)
V_DIODE = 3.3V
100
nA
V_SIG
Signal Voltage
Positive Clamp
Negative Clamp
I_LOAD = 10mA
I_LOAD = -10mA
5.6
6.8
9.0
V
-0.4
-0.8
-1.5
V
V_ESD In-system ESD Withstand Voltage
Notes 2,4 and 5
a) Human Body Model, MIL-STD-883,
±30
kV
Method 3015
b) Contact Discharge per IEC 61000-4-2
±15
kV
Level 4
V_CL Clamping Voltage during ESD Discharge Notes 2,3,4 and 5
MIL-STD-883 (Method 3015), 8kV
Positive Transients
Negative Transients
+12
V
-7
V
f_C
Cut-off Frequency
Z_SOURCE=50Ω, Z_LOAD=50Ω
R = 200Ω, C = 15pF
105
MHz
Note 1: T_A=25°C unless otherwise specified.
Note 2: ESD applied to input and output pins with respect to GND, one at a time.
Note 3: Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin. For example, if ESD is applied to Pin 1,
then clamping voltage is measured at Pin 8.
Note 4: Unused pins are left open
Note 5: These parameters are guaranteed by design and characterization.
© 2004 California Micro Devices Corp. All rights reserved.
08/16/04 430 N. McCarthy Blvd., Milpitas, CA 95035-5112 ● Tel: [phone] ● Fax: [phone] ● www.calmicro.com 3