CM1405 Datasheet, PDF (3/11 Pages) California Micro Devices Corp – LCD EMI Filter Array with ESD Protection

Specifications
PARAMETER
Storage Temperature Range
DC Power per Resistor
DC Package Power Rating
CM1405
ABSOLUTE MAXIMUM RATINGS
RATING
-65 to +150
100
500
UNITS
°C
mW
mW
PARAMETER
Operating Temperature Range
STANDARD OPERATING CONDITIONS
RATING
-40 to +85
UNITS
°C
ELECTRICAL OPERATING CHARACTERISTICS ^{(SEE NOTE 1)}
SYMBOL
R
C
V_DIODE
I_LEAK
V_SIG
V_ESD
V_CL
f_C
PARAMETER
Resistance
Capacitance
Diode Standoff Voltage
Diode Leakage Current (reverse bias)
Signal Voltage
Positive Clamp
Negative Clamp
In-system ESD Withstand Voltage
a) Human Body Model, MIL-STD-883,
Method 3015
b) Contact Discharge per IEC 61000-4-2
Level 4
Clamping Voltage during ESD Discharge
MIL-STD-883 (Method 3015), 8kV
Positive Transients
Negative Transients
Cut-off Frequency
Z_SOURCE=50Ω, Z_LOAD=50Ω
CONDITIONS
At 2.5V DC, 1MHz, 30mV
AC
I_DIODE = 10µA
V_DIODE = 3.3V
I_LOAD = 10mA
I_LOAD = -10mA
Notes 2,4 and 5
Notes 2,3,4 and 5
R = 100Ω, C = 25pF
MIN TYP
80 100
20 25
5.5
100
5.6 6.8
-0.4 -0.8
±30
±30
+12
-7
70
MAX
120
30
9.0
-1.5
UNITS
Ω
pF
V
nA
V
V
kV
kV
V
V
MHz
Note 1: T_A=25°C unless otherwise specified.
Note 2: ESD applied to input and output pins with respect to GND, one at a time.
Note 3: Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin. For example, if ESD is applied to Pin A1,
then clamping voltage is measured at Pin C1.
Note 4: Unused pins are left open
Note 5: These parameters are guaranteed by design and characterization.
© 2004 California Micro Devices Corp. All rights reserved.
06/16/04 430 N. McCarthy Blvd., Milpitas, CA 95035-5112 ● Tel: [phone] ● Fax: [phone] ● www.calmicro.com 3