CM1402 Datasheet, PDF (3/8 Pages) California Micro Devices Corp – SIM Card EMI Filter Array with ESD Protection

Specifications
PARAMETER
Storage Temperature Range
DC Power per Resistor
DC Package Power Rating
CM1402
ABSOLUTE MAXIMUM RATINGS
RATING
-65 to +150
100
300
UNITS
°C
mW
mW
PARAMETER
Operating Temperature Range
STANDARD OPERATING CONDITIONS
RATING
-40 to +85
UNITS
°C
ELECTRICAL OPERATING CHARACTERISTICS¹
SYMBOL
R₁
R₂
C
PARAMETER
Resistance of R₁
Resistance of R₂
Capacitance
V_STANDOFF
I_LEAK
V_SIG
V_ESD
V_CL
f_C1
f_C2
Stand-off Voltage
Diode Leakage Current
Signal Voltage
Positive Clamp
Negative Clamp
In-system ESD Withstand Voltage
a) Human Body Model, MIL-STD-883,
Method 3015
b) Contact Discharge per IEC
61000-4-2
Clamping Voltage during ESD Discharge
MIL-STD-883 (Method 3015), 8kV
Positive Transients
Negative Transients
Cut-off frequency
Z_SOURCE = 50Ω, Z_LOAD = 50Ω
Cut-off frequency
Z_SOURCE = 50Ω, Z_LOAD = 50Ω
CONDITIONS
V_IN = 2.5VDC, 1MHz,
30mV ac
I = 10μA
V_BIAS = 3.3V
I_LOAD = 10mA
I_LOAD = -10mA
Notes 2,4 and 5
Notes 2,3,4 and 5
R = 100Ω, C = 20pF
R = 47Ω, C = 20pF
MIN TYP MAX UNITS
80
100 120
Ω
38
47
56
Ω
16
20
24
pF
6.0
V
0.1
1.0
μA
5.6
6.8
9.0
V
-1.5 -0.8 -0.4
V
±25
kV
±10
kV
+12
V
-7
V
77
MHz
85
MHz
Note 1: T_A=25°C unless otherwise specified.
Note 2: ESD applied to input and output pins with respect to GND, one at a time.
Note 3: Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin. For example, if ESD is applied to Pin A1,
then clamping voltage is measured at Pin C1.
Note 4: Unused pins are left open
Note 5: The parameters are guaranteed by design.
© 2005 California Micro Devices Corp. All rights reserved.
11/02/05
490 N. McCarthy Blvd., Milpitas, CA 95035-5112 ● Tel: [phone] ● Fax: [phone] ● www.cmd.com 3