CSPEMI607 Datasheet, PDF (2/5 Pages) California Micro Devices Corp – 4-Channel LCD EMI Filter Array with ESD Protection plus 4-Channel of ESD Protection Array

California Micro Devices
430 N.McCarthy Blvd
Milpitas, CA 95035
Figure 1. Dimensions of CSPEMI607.
Schematic Diagram
PRELIMINARY
Pin Number
A1
A2
A3
A4
A5
A6
B1
B2
Pin Description
ESD Channel #1
Filter #1
Filter #2
Filter #3
Filter #4
ESD Channel #2
GND
GND
Pin Number
B3
C1
C2
C3
C4
C5
C6
Pin Description
GND
ESD Channel #3
Filter #1
Filter #2
Filter #3
Filter #4
ESD Channel #4
Specifications: (At 25°C unless specified otherwise)
Resistance R1
Capacitance C1 at 2.5V dc; 1MHz, 30mV ac
Stand-off Voltage, I = 10µA
Diode Leakage at +/-3.3V reverse bias voltage
Signal Clamp Voltage:
Positive Clamp, 10mA
Negative Clamp, -10mA
In-system ESD withstand voltage*:
Human Body Model (MIL-STD-883, method 3015)
IEC 61000-4-2, contact discharge method
Clamping voltage during ESD discharge*
MIL-STD-883 (Method 3015), 8kV
Temperature Range:
Operating
Storage
Positive
Negative
DC Power per Resistor:
DC Package Power Rating:
Min.
80
12
5.5
Typ.
100
15
100
Max.
120
18
5.6
6.8
9.0
-1.5 -0.8
-0.4
±30
±15
12
-7
-40
85
-65
150
0.1
0.5
* ESD applied to input / output pins with respect to GND, one at a time. Clamping voltage is
measured at the opposite side of the EMI filter to the ESD pin (i.e. if ESD is applied to pin A1
then clamping voltage is measured at pin C1). Unused pins are left open. These parameters
are guaranteed by design.
Unit
Ω
pF
V
nA
V
V
kV
kV
V
V
°C
W
W
11/18/03 Tel: [phone] • Fax: [phone] • Website: www.calmicro.com
2