PACGTL Datasheet, PDF (1/3 Pages) California Micro Devices Corp – HIGH PERFORMANCE GTL TERMINATION NETWORK FOR SOCKET 370 PROCESSORS

CALIFORNIA MICRO DEVICES
PACGTL
HIGH PERFORMANCE GTL TERMINATION NETWORK
FOR SOCKET 370 PROCESSORS
Features
• 24 terminations in a single package
• 5 chip solution for all 119 GTL terminations
• High speed termination network
• Center ground pin placement reduces ground
bounce and eases board layout
• Very low cross-talk
• Saves board space and reduces assembly cost
Applications
• High Performance Servers
• High Performance Desk Top Systems
• Intel Celeron™ and Pentium™ CPUs
Application Information
High speed microprocessors demand unique, high speed bus termination. The PACGTL Termination Network provides 24
terminations per package and meets the requirements for high speed terminations. The termination resistor values are 56 or
120 ohms each. Five devices provide the necessary terminations for the 32-bit address bus, 64-bit data bus, and the control
of status signals. Potential board layout solutions are included in this datasheet.
This termination network provides high performance, high reliability, and low cost through manufacturing efficiency. The
termination resistor elements are fabricated using state-of-the-art thin film manufacturing. This integrated solution is silicon-
based and has the same reliability characteristics of today’s microprocessor products. The thin film resistors have very high
stability over temperature, over applied voltage, and over life. In addition, the QSOP (SSOP) industry standard packaging is
easy to handle in manufacturing and yields high reliability similar to other semiconductor components.
STANDARD VALUES
Resistor (R)
56 or 120 Ohms
Absolute Tolerance (R)
+5%
TCR
+150ppm
Operating Temperature Range
0°C to 70°C
Max Package Power Rating (70°C)
1.00W
Minimum Insulation Resistance
10,000Meg W
Cross-talk *
4%
STANDARD CONFIGURATION
R(W)
56
120
Code
560
121
Power Rating /
Resistor
100 mW
40 mW
* PAC560GTL or PAC121GTL used as a terminator. Signal on a single victim line when all other lines are driven synchronously and
simultaneously.
STANDARD PART ORDERING INFORMATION
Package
Ordering Part Number
Pins
Style
Part Marking
28
QSOP
PAC560GTL
28
QSOP
PAC121GTL
When placing an order please specify desired shipping: Tubes or Tape & Reel.
All trademarks are the property of their respective holders.
©2000 California Micro Devices Corp. All rights reserved. P/Active^® is a registered trademark and PAC™ is a trademark of California Micro Devices.
2/00
215 Topaz Street, Milpitas, California 95035 Tel: [phone] Fax: [phone]
C0290498D
www.calmicro.com
1