TLV320AIC3105_08 Datasheet, PDF (75/95 Pages) Burr-Brown (TI) – LOW-POWER STEREO AUDIO CODEC FOR PORTABLE AUDIO/TELEPHONY

www.ti.com
TLV320AIC3105
SLAS513A – FEBRUARY 2007 – REVISED JULY 2007
Page 0/Register 96: Sticky Interrupt Flags Register
BIT READ/ RESET
WRITE VALUE
DESCRIPTION
D7
R
0
HPLOUT Short-Circuit Detection Status
0: No short circuit detected at HPLOUT driver
1: Short circuit detected at HPLOUT driver
D6
R
0
HPROUT Short-Circuit Detection Status
0: No short circuit detected at HPROUT driver
1: Short circuit detected at HPROUT driver
D5
R
0
HPLCOM Short-Circuit Detection Status
0: No short circuit detected at HPLCOM driver
1: Short circuit detected at HPLCOM driver
D4
R
0
HPRCOM Short-Circuit Detection Status
0: No short circuit detected at HPRCOM driver
1: Short circuit detected at HPRCOM driver
D3
R
0
Reserved. Do not write to this bit.
D2
R
0
Headset Detection Status
0: No headset insertion/removal is detected.
1: Headset insertion/removal is detected.
D1
R
0
Left ADC AGC Noise Gate Status
0: Left ADC signal power is greater than or equal to noise threshold for left AGC.
1: Left ADC signal power is less than noise threshold for left AGC.
D0
R
0
Right ADC AGC Noise Gate Status
0: Right ADC signal power is greater than or equal to noise threshold for right AGC.
1: Right ADC signal power is less than noise threshold for right AGC.
Page 0/Register 97: Real-Time Interrupt Flags Register
BIT READ/ RESET
WRITE VALUE
DESCRIPTION
D7
R
0
HPLOUT Short-Circuit Detection Status
0: No short circuit detected at HPLOUT driver
1: Short circuit detected at HPLOUT driver
D6
R
0
HPROUT Short-Circuit Detection Status
0: No short circuit detected at HPROUT driver
1: Short circuit detected at HPROUT driver
D5
R
0
HPLCOM Short-Circuit Detection Status
0: No short circuit detected at HPLCOM driver
1: Short circuit detected at HPLCOM driver
D4
R
0
HPRCOM Short-Circuit Detection Status
0: No short circuit detected at HPRCOM driver
1: Short circuit detected at HPRCOM driver
D3
R
0
Reserved. Do not write to this bit.
D2
R
0
Headset Detection Status
0: No headset insertion/removal is detected.
1: Headset insertion/removal is detected.
D1
R
0
Left ADC AGC Noise Gate Status
0: Left ADC signal power is greater than noise threshold for left AGC.
1: Left ADC signal power lower than noise threshold for left AGC.
D0
R
0
Right ADC AGC Noise Gate Status
0: Right ADC signal power is greater than noise threshold for right AGC.
1: Right ADC signal power is lower than noise threshold for right AGC.
BIT
D7–D0
READ/
WRITE
R
Page 0/Register 98–100: Reserved Registers
RESET
VALUE
0000 0000 Reserved. Do not write to these registers.
DESCRIPTION
Submit Documentation Feedback
75