|
DRV401 Datasheet, PDF (5/28 Pages) Burr-Brown (TI) – Sensor Signal Conditioning IC for Closed-Loop Magnetic Current Sensor | |||
|
◁ |
www.ti.com
PIN CONFIGURATIONS
Top View
DRV401
SBVS070A â JUNE 2006 â REVISED OCTOBER 2006
RGW Top View
DWP
ERROR 1
DEMAG 2
GAIN 3
REFOUT 4
REFIN 5
Exposed
Thermal Pad
on Underside,
Connect
to GND1
15 VDD1
14 OVERâRANGE
13 CCdiag
12 VDD2
11 ICOMP1
QFNâ20 (5mm x 5mm)
PWM 1
PWM 2
ERROR 3
DEMAG 4
GAIN 5
REFOUT 6
REFIN 7
VOUT 8
IAIN2 9
IAIN1 10
Exposed
Thermal Pad
on Underside,
Connect
to GND1
20 IS1
19 GND1
18 IS2
17 VDD1
16 OVERâRANGE
15 CCdiag
14 VDD2
13 ICOMP1
1 2 ICOMP2
11 GND2
WideâBody SOâ20
NAME
ERROR
DEMAG
GAIN
REFOUT
REFIN
VOUT
IAIN2
IAIN1
GND2
ICOMP2
ICOMP1
VDD2
CCdiag
OVERâRANGE
VDD1
IS2
GND1
IS1
PWM
PWM
Exposed Thermal Pad
PIN ASSIGNMENTS
NO. DESCRIPTION
1 Error flag: open-drain output, see the Error Conditions section.
2 Control input, see the Demagnetization section.
3 Control input for open-loop gain: low = normal, high = â8dB.
4 Output for internal 2.5V reference voltage.
5 Input for zero reference to differential amplifier.
6 Output for differential amplifier.
7 Noninverting input of differential amplifier.
8 Inverting input of differential amplifier.
9 Ground connection. Connect to GND1.
10 Output 2 of compensation coil driver.
11 Output 1 of compensation coil driver.
12 Supply voltage. Connect to VDD1.
13 Control input for wire-break detection: high = enable.
14 Open-drain output for over-range indication: low = over-range.
15 Supply voltage.
16 Probe connection 2.
17 Ground connection.
18 Probe connection 1.
19 PWM output from probe circuit (inverted).
20 PWM output from probe circuit.
â Connect to GND1.
5
|
▷ |