DRV102 Datasheet, PDF (3/19 Pages) Burr-Brown (TI) – PWM SOLENOID/VALVE DRIVER

CONNECTION DIAGRAMS
Top Front View
TO-220, DDPAK
7-Lead
Stagger-Formed
TO-220
7-Lead
DDPAK
Surface-Mount
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Supply Voltage, V_S .............................................................................. 60V
Input Voltage .......................................................................... –0.2V to V_S
PWM Adjust Input ................................................ –0.2V to V_S (24V max)
Delay Adjust Input ................................................ –0.2V to V_S (24V max)
Operating Temperature Range ...................................... –55°C to +125°C
Storage Temperature Range ......................................... –55°C to +125°C
Junction Temperature .................................................................... +150°C
Lead Temperature (soldering, 10s)⁽²⁾ ........................................... +300°C
NOTES: (1) Stresses above these ratings may cause permanent damage.
Exposure to absolute maximum conditions for extended periods may de-
grade device reliability. (2) Vapor-phase or IR reflow techniques are recom-
mended for soldering the DRV102F surface-mount package. Wave soldering
is not recommended due to excessive thermal shock and “shadowing” of
nearby devices.
1234567
1234567
In _PWM V_{S Flag}
Delay Gnd Out
In PWM V_{S Flag}
Delay Gnd Out
NOTE: Tabs are electrically connected to ground (pin 4).
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Burr-Brown
recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and
installation procedures can cause damage.
ESD damage can range from subtle performance degradation to
complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes
could cause the device not to meet its published specifications.
PACKAGE/ORDERING INFORMATION
PRODUCT
DRV102T
DRV102F
"
PACKAGE
7-Lead Stagger-Formed TO-220
7-Lead DDPak Surface Mount
"
PACKAGE
DRAWING
NUMBER⁽¹⁾
327
328
"
SPECIFIED
TEMPERATURE
RANGE
–55°C to +125°C
–55°C to +125°C
"
PACKAGE
MARKING
DRV102T
DRV102F
"
ORDERING
NUMBER⁽²⁾
DRV102T
DRV102F
DRV102F/500
TRANSPORT
MEDIA
Rails
Rails
Tape and Reel
NOTES: (1) For detailed drawing and dimension table, please see end of data sheet, or Appendix C of Burr-Brown IC Data Book. (2) Models with a slash (/)
are available only in Tape and Reel in the quantities indicated (e.g., /500 indicates 500 devices per reel). Ordering 500 pieces of “DRV102F/500” will get a single
500-piece Tape and Reel. For detailed Tape and Reel mechanical information, refer to Appendix B of Burr-Brown IC Data Book.
®
3
DRV102