8151 Datasheet, PDF (1/4 Pages) Bi technologies – Position Sensor

Model 8150
Position Sensor
7/8” Diameter
10 turn* Non-Contacting
Hall Effect
MODEL STYLES AVAILABLE
8151
8153
8154
8156
1/8” Shaft, 1/4” Bushing
1/8” Shaft, Servo Mount
6 mm shaft, 3/8” Bushing
1/4” shaft, 3/8” Bushing
ELECTRICAL¹
Input Voltage
Output Voltage
Output Overvoltage Limits
Output Current
Output Load
Supply Voltage Absolute Limits
Independent Linearity²
Hysteresis
Resolution
Supply Current
Dielectric Strength
Insulation Resistance
Electrostatic Discharge (ESD)
Bulk Current Injection (BCI)
Actual Electrical Travel
Temperature Coefficient of Output Voltage
4.5 to 5.5 Vdc nominal
0.2 Vdc (4%) to 4.8 Vdc (96%) Typical (see Feature Codes table)
10 Vdc to -0.3 Vdc; output may be shorted to ground or supply without damage
±15 mA maximum
1 kΩ Min., 10 kΩ typical
20 Vdc Max., -10 Vdc minimum
±0.5% (0.25% Available)
10° maximum (10 turn), 5° maximum (5 turn), 3° maximum (3 turn)
0.88° for 3600° travel, 0.44° for 1800° travel, 0.27° for 1080° travel
8.5 mA typical, 12 mA maximum
750 V rms
1,000 MegΩ minimum
Passes 2 kV human body model and 15 kV air discharge
Passes 2-500 MHz at 200 mA
Same as mechanical travel
± 20 ppm/°C
MECHANICAL
Total Mechanical Travel
Bearing
Weight
Panel Nut Tightening Torque
Start/Run Torque (ES option adds 0.5 oz.-in.)
Up to 3600° continuous
Bushing models use bronze sleeve, Servo model uses two ball bearings
0.7 oz nominal
25 in. lb. maximum
< 0.1 oz-in
1 _{Specifications subject to change without notice.}
2 _{Linearity is measured per voltage code range, inset by 1% of input voltage on each end.}
* Model available in 3 & 5 turn versions.
BI Technologies Corporation
4200 Bonita Place, Fullerton, CA 92835 USA
Phone: [phone] Website: www.bitechnologies.com
February 16 2016
Model 8150 page 1 of 4
Pb RoHS 2
compliant