English
Language : 

AZ100EL16VS Datasheet, PDF (1/8 Pages) List of Unclassifed Manufacturers – ECL/PECL Differential Receiver with Variable Output Swing
AZ100EL16VS
ARIZONA MICROTEK, INC.
ECL/PECL Differential Receiver with Variable Output Swing
FEATURES
• 250ps Propagation Delay
• High Bandwidth Output Transitions
• 75kΩ Internal Input Pulldown Resistors
• Functionally Equivalent to ON
Semiconductor MC100EL16
• Variable Output Swing
• Available in a 3x3mm MLP Package
PACKAGE AVAILABILITY
PACKAGE PART NUMBER MARKING NOTES
MLP 8
AZ100EL16VSL
AZM16P
<Date Code>
1,2
SOIC 8
AZ100EL16VSD
AZM100
EL16VS
1,3
TSSOP 8
AZ100EL16VST
AZH16VS
1,3
1 Add R1 at end of part number for 7 inch (1K parts), R2 for 13 inch (2.5K parts)
Tape & Reel.
2 Date Code “YWW”
3 Date Code “YWW” on underside of part.
DESCRIPTION
The AZ100EL16VS is a differential receiver with variable output swing. The EL16VS has functionality and
output transition times similar to the EL16, with an input that controls the amplitude of the Q/Q¯ outputs. Maximum
swing is achieved by leaving the VCTRL pin open or tied to VEE.
The operational range of the EL16VS control input, VCTRL, is from VBB (full swing) to VCC (min. swing).
Simple control of the output swing can be obtained by a variable resistor between the VBB and VCC pins, with the
wiper driving VCTRL. Typical application circuits and results are described in this Data Sheet.
The EL16VS provides a VBB output for single-ended use or a DC bias reference for AC coupling to the device.
For single-ended input applications, the VBB reference should be connected to one side of the D/D¯ differential input
pair. The input signal is then fed to the other D/D¯ input. The VBB pin can support 1.0mA sink/source current.
When used, the VBB pin should be bypassed to ground via a 0.01μF capacitor.
Under open input conditions (pulled to VEE) internal input clamps will force the Q output LOW.
NOTE: Specifications in ECL/PECL tables are valid when thermal equilibrium is established.
1630 S. STAPLEY DR., SUITE 127 • MESA, ARIZONA 85204 • USA • (480) 962-5881 • FAX (480) 890-2541
www.azmicrotek.com