G150X1-L02 Datasheet, PDF (11/27 Pages) AZ Displays – TFT LCD Approval Specification

Doc No.:
Issued Date:Dec.15,2006
Model No.: G150X1-L02
Approval
The output of the inverter must have symmetrical (negative and positive) voltage waveform and
symmetrical current waveform.(Unsymmetrical ratio is less than 10%) Please do not use the inverter
which has unsymmetrical voltage and unsymmetrical current and spike wave. Lamp frequency may
produce interface with horizontal synchronous frequency and as a result this may cause beat on the
display. Therefore lamp frequency shall be as away possible from the horizontal synchronous
frequency and from its harmonics in order to prevent interference.
Requirements for a system inverter design, which is intended to have a better display performance, a
better power efficiency and a more reliable lamp. It shall help increase the lamp lifetime and reduce its
leakage current.
a. The asymmetry rate of the inverter waveform should be 10% below;
b. The distortion rate of the waveform should be within 2 ± 10%;
c. The ideal sine wave form shall be symmetric in positive and negative polarities
* Asymmetry rate:
Ip
| I _p – I _–p | / I_rms * 100%
I -p
* Distortion rate
I _p (or I _–p) / I_rms
4. BLOCK DIAGRAM
4.1 TFT LCD MODULE
LVDS
INPUT
LVDS
INPUT
TIMING
CONTROLLER
TFT LCD PANEL
(1024x3x768)
DC
POWER
SUPPLY
DC/DC CONVERTER &
REFERENCE VOLTAGE
GENERATOR
LAMP CONNECTOR
(JST BHR-03VS-1)
DATA DRIVER IC
BACKLIGHT UNIT
11 / 27
Version 2.0