ACPL-352J Datasheet, PDF (8/26 Pages) AVAGO TECHNOLOGIES LIMITED – 5.0 A maximum peak output current

ACPL-352J
Data Sheet
Table 3. Absolute Maximum Ratings
Table 3. Absolute Maximum Ratings
Parameter
Symbol
Min.
Max.
Units
Note
Storage Temperature
T_S
–55
125
°C
Operating Temperature
T_A
–40
105
°C
Output IC Junction Temperature
T_J
125
°C
Average Input Current
I_F(AVG)
25
mA
a
Peak Transient Input Current (<1 μs pulse width, 300pps)
I_F(TRAN)
1.0
A
Reverse Input Voltage
V_R
5
V
"High" Peak Output Current
I_OH(PEAK)
5
A
b
"Low" Peak Output Current
I_OL(PEAK)
5
A
b
Positive Input Supply Voltage
V_DD1
0
7
V
FAULT Output Current
I_FAULT
8
mA
FAULT Pin Voltage
V_FAULT
–0.5
V_DD1
V
Total Output Supply Voltage
(V_DD2 – V_SS2)
–0.5
35
V
Negative Output Supply Voltage
(V_S – V_SS2)
–0.5
17
V
Positive Output Supply Voltage
(V_DD2 – V_S)
–0.5
35 – (V_S – V_SS2) V
Input Current (Rise/Fall Time)
t_r(IN)/t_f(IN)
500
ns
High Side Pull Up Voltage
V_OUTP
V_SS2 – 0.5 V_DD2 + 0.5
V
Low Side Pull Down Voltage
V_OUTN
V_SS2 –0.5
V_DD2 + 0.5
V
Over Current Pin Voltage
V_OC
V_S – 0.5
V_DD2 + 0.5
V
Peak Clamp Sinking Current
I_CLAMP
3
A
b
Miller Clamp Pin Voltage
V_CLAMP
V_SS2 – 0.5 V_DD2 + 0.5
V
Output IC Power Dissipation
P_O
600
mW
c
Input LED Power Dissipation
P_I
110
mW
d
a. Derate linearly above 70°C free-air temperature at a rate of 0.3 mA/°C.
b. Maximum pulse width = 10μs.The output must be limited to –5.0 A/5.0 A of peak current by external resistors. See supply and ground planes layout and
loading conditions section in the applications notes at the end of this data sheet to prevent output noise at 5A rated current.
c. Derate linearly above 95°C free-air temperature at a rate of 20 mW/°C.
d. Derate linearly above 95°C free-air temperature at a rate of 3.7 mW/°C. The maximum LED junction temperature should not exceed 125°C.
Avago Technologies
-8-