HCPL-314J_11 Datasheet, PDF (6/14 Pages) AVAGO TECHNOLOGIES LIMITED – 0.4 Amp Output Current IGBT Gate Drive Optocoupler

Package Characteristics
For each channel unless otherwise specified.
Parameter
Symbol Min. Typ. Max. Units Test Conditions Fig.
Note
Input-Output Momentary
Withstand Voltage
Output-Output Momentary
Withstand Voltage
V_ISO
V_O-O
5000
1500
Vrms T_A=25°C,
8,9
RH<50%
Vrms ^{for 1 min.}
16
Input-Output Resistance
R_I-O
10¹²
Ω
V_I-O=500 V
9
Input-Output Capacitance
C_I-O
1.2
pF
Freq=1 MHz
Notes:
1. Derate linearly above 70°C free air temperature at a rate of 0.3 mA/°C.
2. Maximum pulse width = 10 μs, maximum duty cycle = 0.2%. This value is intended to allow for component tolerances for designs with I_O
peak minimum = 0.4 A. See Application section for additional details on limiting I_OL peak.
3. Derate linearly above 85°C, free air temperature at the rate of 4.0 mW/°C.
4. Input power dissipation does not require derating.
5. Maximum pulse width = 50 μs, maximum duty cycle = 0.5%.
6. In this test, V_OH is measured with a DC load current. When driving capacitive load V_OH will approach V_CC as I_OH approaches zero amps.
7. Maximum pulse width = 1 ms, maximum duty cycle = 20%.
8. In accordance with UL 1577, each HCPL-314J optocoupler is proof tested by applying an insulation test voltage ≥ 6000 Vrms for 1 second.
This test is performed before 100% production test for partial discharge (method B) shown in the IEC/EN/DIN EN 60747-5-2 Insulation Char-
acteristics Table, if applicable.
9. Device considered a two-terminal device: pins on input side shorted together and pins on output side shorted together.
10. PDD is the difference between t_PHL and t_PLH between any two parts or channels under the same test conditions.
11. Pins 3 and 4 (HCPL-314J) need to be connected to LED common.
12. Common mode transient immunity in the high state is the maximum tolerable |dVcm/dt| of the common mode pulse V_CM to assure that the
output will remain in the high state (i.e. Vo > 6.0 V).
13. Common mode transient immunity in a low state is the maximum tolerable |dV_CM/dt| of the common mode pulse, V_CM, to assure that the
output will remain in a low state (i.e. Vo < 1.0 V).
14. This load condition approximates the gate load of a 1200 V/25 A IGBT.
15. For each channel. The power supply current increases when operating frequency and Qg of the driven IGBT increases.
16. Device considered a two terminal device: Channel one output side pins shorted together, and channel two output side pins shorted togeth-
er.
6