HCPL-7601 Datasheet, PDF (2/13 Pages) AVAGO TECHNOLOGIES LIMITED – Isolated line receiver

The HCPL-7601/11 family offers
many features that are especially
beneficial to system designers. The
low input current requirements
and guaranteed switching
threshold (2 mA max.) allows the
LED to be driven directly by any
standard high-speed CMOS gate
(e.g. 74HC/HCT). This will simplify
designs by eliminating the need for
special driver circuits and result in
lower part counts and greater
system reliability while freeing up
valuable printed circuit board
space.
The wide current input range of
2 mA to 10 mA and guaranteed ac
and dc performance over a wide
temperature range will also
simplify designs. Low supply
current requirements mean lower
power dissipation allowing for the
use of a smaller, less expensive
power supply. The high speed
(10 Mbd typ.) and low propagation
delay skew (T_psk ≤ 40 ns
guaranteed) allow for easier
design of high speed parallel
applications. The world-wide
regulatory approval (UL/CSA/IEC/
EN/DIN EN 60747-5-2) will
facilitate the acceptance of the end
product in international markets.
Regulatory Information
The HCPL-7601 and HCPL-7611
have been approved by the
following organizations:
UL
Approved under UL 1577,
component recognition FILE
E55361).
IEC/EN/DIN EN 60747-5-2
Approved under:
IEC 60747-5-2:1997 + A1:2002
EN 60747-5-2:2001 + A1:2002
DIN EN 60747-5-2 (VDE 0884
Teil 2):2003-01
This optocoupler is suitable for
“safe electrical isolation” only
within the safety limit data.
Maintenance of the safety data
shall be ensured by means of
protective circuits.
Can be used for safe electrical
separation between ac mains and
SELV (safety extra-low voltage) in
equipment according to the
following specifications:
DIN VDE 0804/05.89
DIN VDE 0160/05.88
Reference voltage (VDE 011b Tab
4): 630 Vac.
CSA
Approved under CSA22.2 No. 0 -
General Requirements, Canadian
Electrical Code, Part II; and CSA
Component Acceptance Notice #5,
File CA 88324.
2