AMMC-5025 Datasheet, PDF (2/11 Pages) AVAGO TECHNOLOGIES LIMITED – 30KHz – 80 GHz TWA

Absolute Maximum Ratings^{[1,2,3, and 4]}
Symbol
Parameters
Unit
Max
V_d
Positive Supply Voltage^[2]
V
7
V_g1
Gate Supply Voltage
V
-3.6 to 0
V_g2
Gate Supply Voltage
V
-2.5 to +2.5
P_D
Power Dissipation^[2]
W
0.8
P_in
CW Input Power
dBm
23
T_ch
Operating Channel Temp.
°C
+150
T_stg
Storage Case Temp.
°C
-65 to +155
T_max
Maximum Assembly Temp (30 sec max)
°C
+320
Notes:
1. Operation in excess of any one of these conditions may result in permanent damage to this device.
2. Combinations of supply voltage and drain current shall not exceed P_D.
3. The operating channel temperature will directly affect the device MTTF. For maximum life, it is recommended that junction temperatures be
maintained at the lowest possible levels.
DC Specifications/ Physical Properties ^[5]
Symbol
Parameters and Test Conditions
Unit
Min
Vd
Drain Supply Voltage
V
I_d(q)
Drain Supply Current (V_d=5 V, V_g set for I_d(q)Typical)
mA
V_g1
Gate Supply Operating Voltage (I_d(q) = 100 mA)
V
-3.6
V_g2
Gain control voltage. Open on the V_g2 makes highest gain.
V
-2.5
RT_jc
Thermal Resistance^[5] (Channel-to-Backside)
°C/W
T_ch
Channel Temperature @85°C Backside
°C
Typ
Max
5
100
-2.0
-1.2
+1.2
+2.5
12.8
91.4
RF Specifications ^[1,2]
T_A= 25°C, V_dd = 5 V, I_dq =0.1 A, Z_o=50 :
Symbol
Parameters and Test Conditions
Units
Minimum Typical
Freq
Operational Frequency
GHz
30KHz
Gain
Small-signal Gain Freq = 2, 10, 20, 30, 40 GHz
dB
7.5
8
P_-1dB
Output Power at 1dB Gain Compression Freq = 40GHz
dBm
13
15
OIP3
Third Order Output Intercept Point@20GHz 'f = 10MHz,
dBm
20
Po = +10dBm, SCL
RL_in
Input Return Loss
dB
10
RL_out
Output Return Loss
dB
15
Isolation Reverse Isolation
dB
27
Notes:
1. Small/Large -signal data measured from an on-wafer tester at T_A = 25°C.
2. 100% on-wafer RF test of Gain, Return Losses and Reverse Isolation is done at frequencies: 2,10, 20, 30, and 40 GHz.
Maximum
80
2