HFBR-2521Z Datasheet, PDF (18/18 Pages) AVAGO TECHNOLOGIES LIMITED – Versatile Link The Versatile Fiber Optic Connection

HFBR-25X3Z Receiver
DO NOT CONNECT 5
DO NOT CONNECT 8
4 ^VCC
3 ^OPEN
2 ^GROUND
1 ^VO
Pin #
Function
1
V_O
2
Ground
3
Open
4
V_CC
5
Do not connect
8
Do not connect
Note: Pins 5 and 8 are for mounting and retaining purposes only.
Do not electrically connect these pins.
Absolute Maximum Ratings
Parameter
Symbol
Min.
Max.
Storage Temperature
T_S
–40
+85
Operating Temperature
T_A
–40
+85
Lead Soldering Cycle   
Temp.
260
              Time
10
Supply Voltage
V_CC
–0.5
7
Average Output Collector Current
I_O
–1
5
Output Collector Power Dissipation
P_OD 25
Output Voltage
V_O
–0.5
7
Units
Reference
°C
°C
°C
Note 1, 3
sec
V
Note 2
mA
mW
V
Notes:
1. 1.6 mm below seating plane.
2. It is essential that a bypass capacitor 0.1 µF be connected from pin 2 to pin 4 of the receiver.
3. Moisture sensitivity level (MSL) is 3.
Receiver Electrical/Optical Characteristics 0°C to 70°C, 4.5 V ≤V_CC ≤5.5 V unless otherwise specified.
Parameter
Symbol Min. Typ. Max. Units
Conditions
Input Optical Power
P_R(L)
–39 –13.7 dBm V_O = V_OL, I_OL = 3.2 mA
Level Logic 0
–39
–13.3
V_O = V_OL,
^IOH ^{= 8 mA, 25°C}
Input Optical Power
P_R(H) –53 dBm V_OH = 5.5 V
Level Logic 1 I_OH = ≤40 µA
High Level Output Voltage
V_OH
2.4 V I_O = -40 µA, P_R = 0 µW
Low Level Output Voltage
V_OL 0.4
V I_OL = 3.2 mA
P_R = P_R(L)MIN
High Level Supply Current
I_CCH 1.2
1.9
mA V_CC = 5.5 V, P_R = 0 µW
Low Level Supply Current
I_CCL 2.9
3.7
mA V_CC = 5.5 V,
P_R = P_RL (MIN)
Effective Diameter
D 1 mm
Numerical Aperture
NA
0.5
Ref.
Notes 1,
2, 3
Note 3
Note 4
Note 4
Notes:
1. Measured at the end of the fiber optic cable with large area detector.
2. Optical flux, P (dBm) = 10 Log P(µW)/1000 µW.
3. Because of the very high sensitivity of the HFBR-25X3Z, the digital output may switch in response to ambient light levels when a cable is not
occupying the receiver optical port. The designer should take care to filter out signals from this source if they pose a hazard to the system.
4. Including current in 3.3 k pull-up resistor.
For product information and a complete list of distributors, please go to our website: www.avagotech.com
Avago, Avago Technologies, and the A logo are trademarks of Avago Technologies in the United States and other countries.
Data subject to change. Copyright © 2005-2011 Avago Technologies. All rights reserved. Obsoletes 5989-4630EN
AV02-1501EN - August 25, 2011