HCPL-M700 Datasheet, PDF (1/9 Pages) Agilent(Hewlett-Packard) – Small Outline, 5 Lead, Low Input Current, High Gain Optocouplers

HCPL-M700/HCPL-M701
Small Outline, 5 Lead, Low Input Current, High Gain Optocouplers
Data Sheet
Description
Features
These small outline, low input current, high gain
optocouplers are single channel devices in a five lead
miniature footprint. They are electrically equivalent
to the following Avago optocouplers:
• Surface mountable
• Very small, low profile JEDEC registered package outline
• Compatible with infrared vapor phase reflow and wave
soldering processes
The SO-5 JEDEC registered (MO-155) package outline
does not require “through holes” in a PCB. This
package occupies approximately one-fourth the
footprint area of the standard dual-in-line package.
The lead profile is designed to be compatible with
standard surface mount processes.
• High current transfer ratio: 2000%
• Low input current capability: 0.5 mA
• TTL compatible output: V_OL = 0.1 V
• Guaranteed ac and dc performance over temperature:
0°C to 70°C
• High output current: 60 mA
These high gain series opto-couplers use a Light
Emitting Diode and an integrated high gain photo-
detector to provide extremely high current transfer
ratio between input and output. Separate pins for
the photodiode and output stage results in TTL
compatible saturation voltages and high speed
operation. Where desired the V_CC and V_O terminals
may be tied together to achieve conventional photo-
darlington operation.
The HCPL-M701 is for use in CMOS, LSTTL or other
low power applications. A 400% minimum current
transfer ratio is guaranteed over a 0-70°C operating
range for only 0.5 mA of LED current.
• Recognized under the component program of U.L. (file No.
E55361) for dielectric withstand proof test voltage of 3750
Vac, 1 minute
• Lead free option “-000E”
Applications
• Ground isolate most logic families: TTL/TTL, CMOS/TTL,
CMOS/CMOS, LSTTL/TTL, CMOS/LSTTL
• Low input current line receiver
• EIA RS232C line receiver
• Telephone ring detector
• ac line voltage status indicator:
low input power dissipation
• Low power systems: ground isolation
The HCPL-M700 is designed for use mainly in TTL
applications. Current Transfer Ratio is 300%
minimum over 0-7°0C for an LED current of 1.6 mA
[1 TTL Unit Load (U.L.)]. A 300% CTR enables operation
with 1 U.L. out with a 2.2 kΩ pull-up resistor.
Selection for lower input currents down to 250 µA is
available upon request.
SO-5 Package
HCPL-M700
HCPL-M701
Standard DIP
6N138
6N139
SO-8 Package
HCPL-0700
HCPL-0701
CAUTION: The small device geometries inherent to the design of this bipolar component increase the component’s
susceptibility to damage from electrostatic discharge (ESD). It is advised that normal static precautions be taken in
handling and assembly of this component to prevent damage and/or degradation which may be induced by ESD.