ACNV260E Datasheet, PDF (1/10 Pages) AVAGO TECHNOLOGIES LIMITED – 2mm DTI, 10MBd Digital Optocoupler 13mm creepage and clearance

ACNV260E
2mm DTI, 10MBd Digital Optocoupler
Data Sheet
Description
The new ACNV260E is an optically coupled gate that
combines a AlGaAs light emitting diode and an inte-
grated photo detector housed in a widebody package.
ACNV260E is designed and manufactured to comply
with EN60079-11 ATEX and IECEx. The distance-through-
insulation (DTI) between the emitting diode and photo-
detector is at 2mm. The output of the detector IC is an
open collector Schottky clamped transistor. The internal
shield provides a guaranteed common mode transient
immunity specification of 20,000 V/μs at V_cm = 1500V
This unique design provides maximum ac and dc circuit
isolation while achieving TTL compatibility.
The new ACNV260E is suitable for high speed logic inter-
facing, input/output buffering, as line receivers in envi-
ronments that conventional line receivers cannot tolerate
and are recommended for use in extremely high ground
or induced noise environments.
Functional Diagram
NC 1
Anode 2
Cathode 3
NC 4
NC 5
SHIELD
10 Vcc
9 Ve
8 Vo
7 GND
6 NC
Truth Table
(Positive Logic)
LED ENABLE OUTPUT
On H
L
Off H
H
On L
H
Off L
H
On NC
L
Off NC
H
Features
• Compliant to EN60079-11 ATEX and IECEx (375V)
• 2mm DTI
• 13mm creepage and clearance
• 20 kV/μs Minimum Common Mode Rejection (CMR) at
VCM = 1500 V
• High Speed: 10 MBd Typical
• TTL Compatible
• Guaranteed ac and dc performance over temperature:
-40°C to +105°C
• Available in 10-Pin widebody packages
• Safety Approval
– Approval at 5000 Vrms for 1 minute per UL1577
– CSA
Applications
• High Voltage insulation
• Intrinsic safety circuit
• PCB Board Power System Isolation
• Industrial Equipment Power Isolation
A 0.1 μF bypass capacitor must be connected between pins V_CC and
GND.
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.