ATZB-RF-212B-0-U_14 Datasheet, PDF (8/21 Pages) ATMEL Corporation – ZIGBIT 900MHZ WIRELESS MODULES

3. Specification
3.1 Electrical Characteristics
3.1.1 Absolute Maximum Ratings
Table 3-1. Absolute Maximum Ratings ⁽¹⁾⁽²⁾
Parameter
Voltage on any pin, except RESET with respect to ground
Input RF level
Current into Vcc pins
Minimum
-0.3V
Maximum
3.6V (VDD max)
+10dBm
200mA
Notes: 1. Absolute Maximum Ratings are the values beyond which damage to the device may occur. Under no circumstances must the absolute
maximum ratings given in this table be violated. Stresses beyond those listed under "Absolute Maximum Ratings" may cause permanent
damage to the device.
This is a stress rating only. Functional operation of the device at these or other conditions, beyond those indicated in the operational
sections of this specification, is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device
reliability.
2. Attention! ZigBit is an ESD-sensitive device. Precaution should be taken when handling the device in order to prevent permanent
damage.
3.1.2 Power Supply
Table 3-2. Test Conditions (unless otherwise stated), Vcc = 3V, Tamb = 25^°C.
Parameter
Supply voltage, VDD
Current consumption: RX mode
Current consumption: TX mode, PLL ON
Current consumption: TX mode ⁽¹⁾ – BUSY_TX – Transmit state
Current consumption: TRX_OFF
Sleep Current consumption: TRX Sleep
Range
Unit
1.8 to 3.6
V
9.3
mA
5
mA
26.9
mA
617
µA
0.7
µA
Note 1: Output TX power (when measuring consumption in TX mode) is +9 dBm.
Current consumption depends on multiple factors, including but not limited to, the board design and materials. When this module
is assembled on a base board, the MCU current also should be considered in estimating Active and Sleep currents of the
product
ATZB-RF-212B-0-U [ZigBit 900MHz Wireless Modules]
8
42270B−WIRELESS−08/2014