ATZB-RF-212B-0-U_14 Datasheet, PDF (7/21 Pages) ATMEL Corporation – ZIGBIT 900MHZ WIRELESS MODULES

Depending on end-user design requirements, the ZigBit can operate as a sensor node, where it can be paired with a
host processor driving the module over a serial interface.
The MAC stack running on the host processor can then control data transmission. Thus very minimal firmware
customization is required for successful module design-in. Third-party sensors can then be connected directly to the
host MCU.
Every ZigBit Module come pre loaded with Atmel assigned 64-bit MAC address stored in the EEPROM built-in the
module. This unique IEEE MAC address can be used as the MAC address of the end product, so there is no need to
buy a MAC address separately for the product using the ZigBit.
ATZB-RF-212B-0-U [ZigBit 900MHz Wireless Modules]
7
42270B−WIRELESS−08/2014