AT24C128B_14 Datasheet, PDF (8/23 Pages) ATMEL Corporation – Schmitt Trigger, Filtered Inputs for Noise Suppression

Figure 6-6. Output Acknowledge
SCL
1
8
9
DATA IN
DATA OUT
START
ACKNOWLEDGE
7. Device Addressing
The 128K EEPROM requires an 8-bit device address word following a start condition to enable
the chip for a read or write operation (see Figure 7-1). The device address word consists of a
mandatory “1”, “0” sequence for the first four most significant bits as shown. This is common to
all two-wire EEPROM devices.
Figure 7-1. Device Address
1
0
1
0
A2
A1 A0
R/W
MSB
LSB
The next three bits are the A2, A1, A0 device address bits to allow as many as eight devices on
the same bus. These bits must compare to their corresponding hardwired input pins. The A2,
A1, and A0 pins use an internal proprietary circuit that biases them to a logic low condition if the
pins are allowed to float.
The eighth bit of the device address is the read/write operation select bit. A read operation is ini-
tiated if this bit is high, and a write operation is initiated if this bit is low.
Upon a compare of the device address, the EEPROM will output a “0”. If a compare is not made,
the device will return to a standby state.
DATA SECURITY: The AT24C128B has a hardware data protection scheme that allows the user
to write protect the whole memory when the WP pin is at V_CC.
8 AT24C128B
5296A–SEEPR–1/08