SAM7S32_14 Datasheet, PDF (754/775 Pages) ATMEL Corporation – Internal High-speed Flash

Version
6175K
Comments
Debug and Test Features:
Table 12-2, “SAM7S Series Debug Unit Chip ID” updated.
ERRATA:
2 columns added to Table 40-1, “Errata Summary Table”: SAM7256/128 Rev C and SAM7S64 Rev C.
Corresponding sections added.
Section 40.5 ”SAM7S512 Errata - Revision B Parts” added. Table 40-1, “Errata Summary Table” updated
too.
Ordering Information:
MRL C column added to Table 39-1, “SAM7S Series Ordering Information”.
Change
Request
Ref
7044
7185
7185
Version
6175J Comments
Change
Request
Ref
Overview:
Section 6.2 ”Test Pin”, added to SAM-BA Boot recovery procedure, a power cycle of the board is mandatory.
Section 8.10 ”SAM-BA Boot Assistant”, added to SAM-BA Boot recovery procedure, a power cycle of the
board is mandatory.
6068
Section 19.2.4.4 ”General-purpose NVM Bits”, Clear General-purpose Bit command updated (last paragraph ^6235/5522
in the section).
EFCS:
Section 19.2.4.1 ”Flash Programming”, constraint on partial programming mode added under Figure 19-6
”Example of Partial Page Programming”
6825
USART:
Section 31.7.9 ”USART Baud Rate Generator Register”
6302
ERRATA:
Section 40.4 ”SAM7S512 Errata - Revision A Parts”
Section 40.4.2.1 ”EFC: Embedded Flash Access Time 1”, updated.
6873
Section 40.4.9.4 ”USART: RXBRK Flag Error in Asynchronous Mode”, updated.
Section 40.6.12.4 ”USART: RXBRK Flag Error in Asynchronous Mode”, updated.
Section 40.7.11.4 ”USART: RXBRK Flag Error in Asynchronous Mode”, updated.
Section 40.8.9.4 ”USART: RXBRK Flag Error in Asynchronous Mode”, updated.
Section 40.11.12.4 ”USART: RXBRK Flag Error in Asynchronous Mode”, updated.
Section 40.12.11.4 ”USART: RXBRK Flag Error in Asynchronous Mode”, updated.
Section 40.13.9.4 ”USART: RXBRK Flag Error in Asynchronous Mode”, updated.
6627
SAM7S Series [DATASHEET]
6175M–ATARM–26-Oct-12
754