ATR2406 Datasheet, PDF (5/20 Pages) ATMEL Corporation – LOW IF .4 GHZ ISM TRANSCEIVER

ATR2406 [Preliminary]
Absolute Maximum Ratings
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating
only and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of this
specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
Parameters
Symbol
Min.
Max.
Unit
Supply voltage auxiliary regulator
Supply voltage
Control voltages
Storage temperature
Input RF level
ESD protection
V_S
V_S
V_contr
T_stg
P_RF
V_{ESD_anal}
V_{ESD_dig}
-0.3
-0.3
-0.3
-40
+4.7
+3.6
V_S
+125
+10
TBD
TBD
V
V
V
°C
dBm
V
V
Operating Range
Parameters
Supply voltage
Auxiliary regulator supply voltage
Temperature ambient
Input frequency range
Symbol
V_S
V_{S_BATT}
T_amb
f_RX
Min.
2.9
3.2
-10
2400
Max.
3.6
4.6
+60
2483
Unit
V
V
°C
MHz
Electrical Characteristics
V_S = 3.6 V with AUX regulator, T_amb = 25°C, unless otherwise specified
No. Parameters
Test Conditions
Symbol
Min.
Typ. Max. Unit
1 Supply
1.1 Supply voltage
1.2 Supply voltage
1.3 RX supply current
1.4 TX supply current
1.5 Synthesizer supply current
1.6
Supply current in power-down
mode
With AUX regulator
w/o AUX regulator
CW-mode
CW-mode
With AUX regulator
PU_TRX = 0; PU_REG = 0
V_S
3.2
3.6
4.6
V
V_S
2.9
3.0
3.6
V
I_S
31
mA
I_S
16
mA
I_S
26
mA
I_S
<1
µA
1.7
Supply current in power-down
mode
w/o AUX regulator
PU_TRX = 0; PU_REG = 0
I_S
<1
µA
2 Voltage Regulator
2.1 AUX regulator
VREG
3.0
V
2.2 VCO regulator
VREG_VCO
2.7
V
3 Transmitter Part
3.1 TX data rate
72/144/288/576/1152
kBit/s
3.2 Output power
Over full temperature range, from
2400 MHz to 2483 MHz⁽¹⁾
PTX
0
4
dBm
Notes: 1. Measured and guaranteed only on the Atmel evaluation board, including PCB and balun filter.
2. Timing is determined by external loop filter characteristics. Faster timing can be achieved by modification of loop filter. For
further information refer to Application Note.
5
4779F–ISM–09/04