AT83C5136_14 Datasheet, PDF (46/166 Pages) ATMEL Corporation – Integrated Power Monitor (POR/PFD) to Supervise Internal Power Supply

Figure 13-4. PCA Compare Mode and PCA Watchdog Timer
CF CR
CCF4 CCF3 CCF2 CCF1 CCF0
CCON
0xD8
Write to
CCAPnL Reset
Write to
CCAPnH
CCAPnH
CCAPnL
PCA IT
1
0
Enable
16-bit Comparator
Match
CH
CL
PCA Counter/Timer
RESET⁽¹⁾
CCAPMn, n = 0 to 4
ECOMn CAPPn CAPNn MATn TOGn PWMn ECCFn
0xDA to 0xDE
CIDL WDTE
CPS1 CPS0 ECF ^CMOD
0xD9
Note: 1. Only for Module 4
Before enabling ECOM bit, CCAPnL and CCAPnH should be set with a non zero value, other-
wise an unwanted match could happen. Writing to CCAPnH will set the ECOM bit.
Once ECOM set, writing CCAPnL will clear ECOM so that an unwanted match doesn’t occur
while modifying the compare value. Writing to CCAPnH will set ECOM. For this reason, user
software should write CCAPnL first, and then CCAPnH. Of course, the ECOM bit can still be
controlled by accessing to CCAPMn register.
13.3
High Speed Output Mode
In this mode, the CEX output (on port 1) associated with the PCA module will toggle each time a
match occurs between the PCA counter and the module's capture registers. To activate this
mode the TOG, MAT, and ECOM bits in the module's CCAPMn SFR must be set (see
Figure 13-5).
A prior write must be done to CCAPnL and CCAPnH before writing the ECOMn bit.
46 AT83C5134/35/36
7683C–USB–11/07