AT24C16B_08 Datasheet, PDF (22/27 Pages) ATMEL Corporation – Two-wire Serial EEPROM

12.4 8Y6 - Mini Map
Pin 1
Index
Area
A
D2
b
(8X)
Pin 1 ID
L (8X)
D
e (6X)
A2
A1
1.50 REF.
A3
COMMON DIMENSIONS
(Unit of Measure = mm)
SYMBOL
D
E
D2
E2
A
A1
A2
A3
L
e
b
MIN
NOM MAX NOTE
2.00 BSC
3.00 BSC
1.40
1.50
1.60
-
-
1.40
-
-
0.60
0.0
0.02
0.05
-
-
0.55
0.20 REF
0.20
0.30
0.40
0.50 BSC
0.20
0.25
0.30
2
Notes: 1. This drawing is for general information only. Refer to JEDEC Drawing MO-229, for proper dimensions,
tolerances, datums, etc.
2. Dimension b applies to metallized terminal and is measured between 0.15 mm and 0.30 mm from the terminal tip. If the
terminal has the optional radius on the other end of the terminal, the dimension should not be measured in that radius area.
3. Soldering the large thermal pad is optional, but not recommended. No electrical connection is accomplished to the
device through this pad, so if soldered it should be tied to ground
10/16/07
2325 Orchard Parkway
R San Jose, CA 95131
TITLE
8Y6, 8-lead 2.0 x 3.0 mm Body, 0.50 mm Pitch, Utlra Thin Mini-Map,
Dual No Lead Package (DFN) ,(MLP 2x3)
DRAWING NO. REV.
8Y6
D
22 AT24C16B
5175D–SEEPR–6/08