ATMEGA406_0607 Datasheet, PDF (214/263 Pages) ATMEL Corporation – 8-bit Microcontroller with 40K Bytes In-System Programmable Flash

28.7.8
Reset Register
The Reset Register is a Test Data Register used to reset the part during programming. It is
required to reset the part before entering Programming mode.
A high value in the Reset Register corresponds to pulling the external reset low. The part is reset
as long as there is a high value present in the Reset Register. Depending on the Fuse settings
for the clock options, the part will remain reset for a Reset Time-out period (refer to ”Clock
Sources” on page 26) after releasing the Reset Register. The output from this data register is not
latched, so the reset will take place immediately, as shown in Figure 9-1 on page 40.
28.7.9
Programming Enable Register
The Programming Enable Register is a 16-bit register. The contents of this register is compared
to the programming enable signature, binary code 0b1010_0011_0111_0000. When the con-
tents of the register is equal to the programming enable signature, programming via the JTAG
port is enabled. The register is reset to 0 on Power-on Reset, and should always be reset when
leaving Programming mode.
Figure 28-11. Programming Enable Register
TDI
D
A
0xA370
=
T
A
D
Q
Programming Enable
ClockDR & PROG_ENABLE
TDO
28.7.10
Programming Command Register
The Programming Command Register is a 15-bit register. This register is used to serially shift in
programming commands, and to serially shift out the result of the previous command, if any. The
JTAG Programming Instruction Set is shown in Table 28-12. The state sequence when shifting
in the programming commands is illustrated in Figure 28-13.
214 ATmega406
2548E–AVR–07/06