ATZB-X0-256-4-0-CN_14 Datasheet, PDF (1/26 Pages) ATMEL Corporation – ZIGBIT 900MHZ WIRELESS MODULES

ZIGBIT 900MHZ WIRELESS MODULES
ATZB-X0-256-4-0-CN
DATASHEET
Features
• Compact size (38.5 x 20.0mm)
• High RX sensitivity (-103dBm)
• Outperforming link budget (up to +112dB)
• Up to +9.0dBm output power
• Very low power consumption:
• 8.7mA in RX mode ⁽¹⁾
• 34.8mA in TX mode ⁽¹⁾
• 0.6µA in sleep mode ⁽²⁾
• Ample memory resources (256KB In-System, Self-Programmable Flash memory,
4KB EEPROM, 16KB SRAM)
• Wide range of interfaces (both analog and digital)
• 4-wire SPI, TWI
• ISP, JTAG
• Two analog comparator input
• UART, USART
• Timer, PWM
• Four ADC lines
• External Clock Input, Internal Clock Output
• Up to 32 lines configurable as GPIO
• Preassigned Atmel^® MAC address that can be used on end product
• Capability to use MAC address into the internal EEPROM
• IEEE^® 802.15.4 compliant Transceiver
• 900MHz ISM band
• Serial bootloader
• High Performance Low Power Atmel AVR^® XMEGA^® 8- and 32-bit Microcontroller
• Rapid design-in with built-in Chip Antenna
• RF Test point using MS-147 RF connector
• Small physical footprint and low profile for optimum fit in very small application
boards
• Mesh networking capability
• Easy-to-use low cost development kit
• Single source of support for HW and SW
• Worldwide license-free operation
Notes:
1. MCU is in active state with 3V Supply, CPU clock @ 16MHz, RX RPC enabled (for RX current),
PHY_TX_PWR=0x0 (for TX current), All digital outputs pulled high.
2. Controller Sleep Mode: SLEEP_MODE_PWR_DOWN.
4 22 68 B−W I REL ESS−07 /2 01 4