ATZB-X0-256-3-0-C_14 Datasheet, PDF (1/28 Pages) ATMEL Corporation – ZIGBIT 2.4GHZ WIRELESS MODULES

ZIGBIT 2.4GHZ WIRELESS MODULES
ATZB-X0-256-3-0-C
DATASHEET
Features
• Compact size (33.0 x 20.0mm)
• High RX sensitivity (- 96dBm)
• Outperforming link budget (up to 99.6dB)
• Up to +3.6dBm output power
• Very low power consumption:
• 6.3mA in RX mode⁽¹⁾
• 20.5mA in TX mode⁽¹⁾
• 0.3µA in sleep mode⁽²⁾
• Ample memory resources:
• 256KBytes in-system self-programmable Flash memory, 4KBytes EEPROM,
16KBytes SRAM
• Wide range of interfaces (both analog and digital):
• 4- wire SPI, TWI
• ISP, JTAG
• Two analog comparator input
• UART, USART
• Timer, PWM
• Four ADC lines
• External clock input, internal clock output
• Up to 32 lines configurable as GPIO
• Preassigned Atmel^® MAC address that can be used on end product
• Capability to use MAC address into the internal EEPROM
• IEEE^® 802.15.4 compliant transceiver
• 2.4GHz ISM band
• Serial bootloader
• High performance, low power Atmel^® AVR^® XMEGA^® 8/16-bit Microcontroller
• Rapid design-in with built-in chip antenna
• RF test point using MS-147 RF connector
• Small physical footprint and low profile for optimum fit in very small application
boards
• Mesh networking capability
• Easy-to-use low cost development kit
• Single source of support for HW and SW
• Worldwide license-free operation
Notes: 1. MCU is in active state with 3V Supply, CPU clock @ 16MHz, RX RPC enabled (for RX current),
PHY_TX_PWR=0x0 (for TX current), All digital outputs pulled high.
2. Controller Sleep Mode: SLEEP_MODE_PWR_DOWN.
4 21 72 B−W I REL ESS−03 /2 01 4