ATXMEGA16E5_14 Datasheet, PDF (1/147 Pages) ATMEL Corporation – 8/16-bit Atmel AVR XMEGA Microcontrollers

8/16-bit Atmel AVR XMEGA Microcontrollers
ATxmega32E5 / ATxmega16E5 / ATxmega8E5
DATASHEET
Features
z High-performance, low-power Atmel® AVR® XMEGA® 8/16-bit Microcontroller
z Nonvolatile program and data memories
z 8K –32KBytes of in-system self-programmable flash
z 2K – 4KBytes boot section
z 512Bytes – 1KBytes EEPROM
z 1K – 4KBytes internal SRAM
z Peripheral features
z Four-channel enhanced DMA controller with 8/16-bit address match
z Eight-channel event system
z Asynchronous and synchronous signal routing
z Quadrature encoder with rotary filter
z Three 16-bit timer/counters
z One timer/counter with 4 output compare or input capture channels
z Two timer/counter with 2 output compare or input capture channels
z High resolution extension enabling down to 4ns PWM resolution
z Waveform extension for control of motor, LED, lighting, H-bridge, high drives and more
z Fault extension for safe and deterministic handling and/or shut-down of external driver
z CRC-16 (CRC-CCITT) and CRC-32 (IEEE 802.3) generator
z XMEGA Custom Logic (XCL) module with timer, counter and logic functions
z Two 8-bit timer/counters with capture/compare and 16-bit cascade mode
z Connected to one USART to support custom data frame length
z Connected to I/O pins and event system to do programmable logic functions
z MUX, AND, NAND, OR, NOR, XOR, XNOR, NOT, D-Flip-Flop, D Latch, RS Latch
z Two USARTs with full-duplex and single wire half-duplex configuration
z Master SPI mode
z Support custom protocols with configurable data frame length up to 256-bit
z System wake-up from deep sleep modes when used with internal 8MHz oscillator
z One two-wire interface with dual address match (I²C and SMBus compatible)
z Bridge configuration for simultaneous master and slave operation
z Up to 1MHz bus speed support
z One serial peripheral interface (SPI)
z 16-bit real time counter with separate oscillator and digital correction
z One sixteen-channel, 12-bit, 300ksps Analog to Digital Converter with:
z Offset and gain correction
z Averaging
z Over-sampling and decimation
z One two-channel, 12-bit, 1Msps Digital to Analog Converter
z Two Analog Comparators with window compare function and current sources
z External interrupts on all general purpose I/O pins
z Programmable watchdog timer with separate on-chip ultra low power oscillator
z QTouch® library support
z Capacitive touch buttons, sliders and wheels
z Special microcontroller features
z Power-on reset and programmable brown-out detection
z Internal and external clock options with PLL
z Programmable multilevel interrupt controller
z Five sleep modes
z Programming and debug interface
z PDI (Program and Debug Interface)
z I/O and Packages
z 26 programmable I/O pins
z 7x7mm 32-lead TQFP
z 5x5mm 32-lead VQFN
z 4x4mm 32-lead UQFN
z Operating Voltage
z 1.6 – 3.6V
z Operating frequency
z 0 – 12MHz from 1.6V
z 0 – 32MHz from 2.7V
Atmel 8153I–AVR-ATxmega8E5-ATxmega16E5-ATxmega32E5_Datasheet–08/2014