AT49SN12804 Datasheet, PDF (1/41 Pages) ATMEL Corporation – 128-megabit (8M x 16) Burst/Page Mode 1.8-volt Flash Memory

Features
• 1.65V - 1.95V Read/Write
• High Performance
– Random Access Time – 70 ns
– Page Mode Read Time – 20 ns
– Synchronous Burst Frequency – 66 MHz
– Configurable Burst Operation
• Sector Erase Architecture
– Sixteen 4K Word Sectors with Individual Write Lockout
– Two Hundred Fifty-four 32K Word Main Sectors with Individual Write Lockout
• Typical Sector Erase Time: 32K Word Sectors – 500 ms; 4K Word Sectors – 100 ms
• Thirty-two Plane Organization, Permitting Concurrent Read in Any of the Thirty-one
Planes not Being Programmed/Erased
• Suspend/Resume Feature for Erase and Program
– Supports Reading and Programming Data from Any Sector by Suspending Erase
of a Different Sector
– Supports Reading Any Word by Suspending Programming of Any Other Word
• Low-power Operation
– 30 mA Active
– 10 µA Standby
• VPP Pin for Write Protection and Accelerated Program/Erase Operations
• RESET Input for Device Initialization
• CBGA and TSOP Packages
• Seventeen 128-bit Protection Registers (2,176 Bits)
• Common Flash Interface (CFI)
Description
The AT49SN/SV12804 is a 1.8-volt 128-megabit Flash memory. The memory is
divided into multiple sectors and planes for erase operations. The AT49SN/SV12804
is organized as 8,388,608 x 16 bits. The device can be read or reprogrammed off a
single 1.8V power supply, making it ideally suited for In-System programming. The
device can be configured to operate in the asynchronous/page read (default mode) or
burst read mode (not available for the AT49SV12804). The burst read mode is used to
achieve a faster data rate than is possible in the asynchronous/page read mode. If the
AVD and the CLK signals are both tied to GND and the burst configuration register is
configured to perform asynchronous reads, the device will behave like a standard
asynchronous Flash memory. In the page mode, the AVD signal can be tied to GND or
can be pulsed low to latch the page address. In both cases the CLK can be tied to
GND.
The AT49SN/SV12804 is divided into thirty-two memory planes. A read operation can
occur in any of the thirty-one planes which is not being programmed or erased. This
concurrent operation allows improved system performance by not requiring the sys-
tem to wait for a program or erase operation to complete before a read is performed.
To further increase the flexibility of the device, it contains an Erase Suspend and Pro-
gram Suspend feature. This feature will put the erase or program on hold for any
amount of time and let the user read data from or program data to any of the remain-
ing sectors. There is no reason to suspend the erase or program operation if the data
to be read is in another memory plane.
The VPP pin provides data protection and faster programming and erase times. When
the V_PP input is below 0.4V, the program and erase functions are inhibited. When V_PP
is at 0.9V or above, normal program and erase operations can be performed. With V_PP
at 12.0V, the program (Dual-word Program command) and erase operations are
accelerated.
128-megabit
(8M x 16)
Burst/Page
Mode 1.8-volt
Flash Memory
AT49SN12804
AT49SV12804
Preliminary
Rev. 3314A–FLASH–4/04
1