AT30TSE758_14 Datasheet, PDF (1/60 Pages) ATMEL Corporation – Digital Temperature Sensor with Nonvolatile Registers

NOT RECOMMENDED
FOR NEW DESIGNS
AT30TSE752
Replaced by
AT30TSE752A
AT30TSE754
Replaced by
AT30TSE754A
AT30TSE758
Replaced by
AT30TSE758A
AT30TSE752, AT30TSE754, AT30TSE758
9- to 12-bit Selectable, ±0.5°C Accurate
Digital Temperature Sensor with Nonvolatile Registers
and Serial EEPROM
Features
DATASHEET
See Applicable Errata in Section 16.
 Integrated Temperature Sensor + Nonvolatile Registers + Serial EEPROM
 2-Wire I²C and SMBus^™ compatible serial interface
 Supports SMBus Timeout
 Supports SMBus Alert and Alert Response Address (ARA)
 Selectable addressing allows up to eight devices on the same bus
 Single 2.7V – 5.5V supply
 100kHz and 400kHz compatibility
 Industry standard green (Pb/Halide-free/RoHS compliant) package options
 8-lead SOIC (150-mil)
 8-lead MSOP (3.0mm x 3mm)
 8-pad Ultra Thin DFN (UDFN — 2.0mm x 3.0mm x 0.6mm)
Digital Temperature Sensor Features
 Measures temperature from -55C to +125C
 Highly accurate temperature measurements requiring no external components
 ±1.0°C accuracy (typical) over the -5C to +90C range
 ±2.0°C accuracy (typical) over the -20C to +125C range
 ±3.0°C accuracy (typical) over the -40C to +125C range
 Pin and software compatible to industry-standard LM75-type devices
 User-configurable resolution
 9 to 12 bits (0.5000C to 0.0625C)
 User-configurable high and low temperature limits
 Nonvolatile registers to retain user-configured or pre-defined power-up defaults
 Register locking to prevent erroneous misconfiguration
 Register lockdown for permanent, non-changeable device configuration
 One-Shot mode for single temperature measurement while in Shutdown mode
 ALERT output pin for indicating temperature alarms
 Low power dissipation
 75μA active current (typical) during temperature measurements
 Shutdown mode to minimize power consumption
 1μA active current (typical)
Atmel-8751F-DTS-AT30TSE752-754-758-Datasheet_092013