HPS35 Datasheet, PDF (3/5 Pages) Astec America, Inc – 350-1400 Watts

Pin Assignments
HPS35 Module
Top
Pin Description
1 AC (L)
2 BLANK
3 AC (N)
4 BLANK
5 GND
6 SWP
7 5V RTN
8 COMMON
9 COMMON
10 COMMON
11 COMMON
12 COMMON
13 COMMON
14 V OUT
15 V OUT
16 V OUT
17 V OUT
18 V OUT
19 V OUT
20 BLANK
21 +5 STANDBY
22 TBA
23 FAN MON
24 I²C CLK
Bottom
Pin Description
A AC (L)
B BLANK
C AC (N)
D BLANK
E GND
F -SENSE
H +SENSE
J COMMON
K COMMON
L COMMON
M COMMON
N COMMON
P COMMON
R V OUT
S V OUT
T V OUT
U V OUT
V V OUT
W V OUT
X INHIBIT
Y TBA
Z AC OK
AA DC OK
BB I²C DATA
TOP SIDE 1-24
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
A B C D E F H J K L M N P R S T U V W X Y Z AA AB
Unit Connector
Card Edge Connector with gold fingers double-sided 1.6mm FR-4 PCB
Mating connector:
EDAC 307-048-520-201 or
equivalent
Rating: 5A per contact
Pin 6 - SWP (IN/OUT Signal)
(Single Wire Parallel)
Pin X - Module Inhibit (IN Signal)
SWP Pin is used when
connecting units in parallel
to achieve current sharing.
Current share accuracy is
typically 10% of full load.
Note:
SWP Voltage is 5V at 100% load current
Pin Z - AC OK (OUT Signal)
Pin 23 - Fan Monitor (OUT Signal)
Pin F - --Remote Sense
Pin H - + Remote Sense
Compensates for up to 0.5V drop.
Recommended shielded twisted wire
pair.
Note:
Hi state: Source 100uA @ 4V
Low State: Sink 10mA @ 0.5V
Pin AA - DC OK (OUT Signal)
154 _{North America (USA): 1-888-41-ASTEC Europe (UK): 44 (1384) 842-211 Asia (HK): 852-2437-9662}
rev 02.24.05