DS-01651 Datasheet, PDF (2/2 Pages) All Sensors Corporation – Surface Mount Basic Pressure Sensors

Pressure Sensor Characteristics Maximum Ratings
Supply Voltage VS
Lead Temperature
(soldering 2-4 sec.)
6 Vdc
270°C
Environmental Specifications
Temperature Ranges
Operating
Storage
Humidity Limits
-25 to 85° C
-40 to 125° C
0 to 95% RH
(non condensing)
Standard Pressure Ranges
Ported
Non-ported
Part Number
Part Number
CSM-L05G-LP
CSM-L05G-LF
CSM-L10G-LP
CSM-L10G-LF
CSM-001G-LP
CSM-001G-LF
CSM-005G-LP
CSM-005G-LF
CSM-015G-LP
CSM-015G-LF
CSM-015A-LP
CSM-015A-LF
CSM-030G-LP
CSM-030G-LF
CSM-100G-LP
CSM-100G-LF
Operating Pressure
0 - 5 inH2O
0 - 10 inH2O
0 - 1 PSI
0 - 5 PSI
0 - 15 PSI
0 - 15 PSIA
0 - 30 PSI
0 - 100 PSI
Nominal
8.40
1.65
22.8
12.0
4.40
4.40
2.30
0.96
Common Performance Characteristic
Parameter ⁽¹⁾
Offset Voltage
Temperature Effect on Offset ⁽²⁾
Temperature Effect on Resistance ^(2,6)
Temperature Effect on Span ^(2,6)
Linearity error ^(4,6)
Hysteresis error ⁽⁶⁾
Position Sensitivity (BST-L10G-xx) ⁽⁶⁾
Input Resistance ⁽⁶⁾
Output Resistance ⁽⁶⁾
Long term stability of span ⁽³⁾
Minimum
--
--
2300
-1700
--
--
--
2.7
2.7
--
Sensitivity ⁽¹⁾
Std Dev.
±1.10
±0.19
±2.60
±1.50
±0.58
±0.58
±0.30
±0.13
Units
mV/inH2O
mV/inH2O
mV/PSI
mV/PSI
mV/PSI
mV/PSI
mV/PSI
mV/PSI
Nominal
±1.0
±3
2600
-2200
±0.2
±0.01
±0.01
3.3
3.3
0.1
Maximum
±5.0
--
3300
-2700
±0.5
±0.05
±0.03
4.0
4.0
--
Proof Pressure
3 PSI
3 PSI
5 PSI
15 PSI
45 PSI
30 PSI
100 PSI
200 PSI
Units
mv
uV/V/°C
ppm/°C
ppm/°C
% FSS
% FSS
% FSS
kohms
kohms
% FSS
Specification Notes
note 1: All parameters are measured at 3.0 volt excitation, for the nominal full scale pressure and room temperature unless otherwise specified. Pressure measurements are with
positive pressure to the single port configuration.
note 2: Shift is relative to 25°C.
note 3: Shift is within the first year of operation.
note 4: Measured at one-half full scale rated pressure using best straight line curve fit.
note 5: The span is the algebraic difference between full scale output voltage and the offset voltage.
note 6: Parameter is characterized and not 100% tested. Minimum and Maximum values indicated as a design reference.
All Sensors reserves the right to make changes to any products herein. All Sensors does not assume any liability arising out of the application or use of any product or circuit described
herein, neither does it convey any license under its patent rights nor the rights of others.
DS-0165 Rev C