PD0922J7575D2_14 Datasheet, PDF (4/7 Pages) Anaren Microwave – Ultra Low Profile 0805 Power Divider

Model PD0922J7575D2
Rev E
Mounting Configuration:
In order for Xinger surface mount components to work optimally, the proper impedance transmission lines must be
used to connect to the RF ports. If this condition is not satisfied, insertion loss, Isolation and VSWR may not meet
published specifications.
All of the Xinger components are constructed from ceramic filled PTFE composites which possess excellent electrical
and mechanical stability having X and Y thermal coefficient of expansion (CTE) of 17 ppm/^oC.
An example of the PCB footprint used in the testing of these parts is shown below. In specific designs, the
transmission line widths need to be adjusted to the unique dielectric coefficients and thicknesses as well as varying
pick and place equipment tolerances. In addition, since the PD0922J7575D2 is a Wilkinson power divider, external
0402 150Ω and 300Ω resistors must be mounted in locations R1 and R2 respectively, as shown in the Figure below.
Pad Footprint w/ 0402 Resistor Locations
6X .014
[0.35]
3X Transmission
Line
4X .012
[0.30]
6X .013
[0.33]
R1
.026
[0.66]
R2
Circuit Pattern
Footprint Pad (s)
Solder Resist
Dimensions are in Inches [Millimeters]
Mounting Footprint
Plated thru
hole to
ground
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]
Available on Tape and
Reel for Pick and Place
Manufacturing.