PD0922J7575D2_14 Datasheet, PDF (1/7 Pages) Anaren Microwave – Ultra Low Profile 0805 Power Divider

Model PD0922J7575D2
Rev E
Ultra Low Profile 0805 Power Divider
75Ω to 75Ω
Description
The PD0922J7575D2 is a low profile, sub-miniature Wilkinson power divider in an
easy to use surface mount package and is ideal for high volume manufacturing
while delivering higher performances than traditional printed and lumped element
solutions. It has been designed for the following markets: DVB-S, GSM, DCS, PCS,
WCDMA, GPS, 802.11a+g, Bluetooth, and Zigbee USA.
The PD0922J7575D2 is matched to 75Ω and has a height profile of 0.8 mm. A two
section Wilkinson design results in increased isolation performance. Two external
resistors are required for operation. Components are available on tape and reel for
high volume manufacturing pick and place.
All Xinger components are constructed from ceramic filled PTFE composites which
possess excellent electrical and mechanical stability having X and Y thermal
coefficient of expansion (CTE) of 17 ppm/^oC.
Detailed Electrical Specifications: Specifications subject to change without notice.
ROOM (25°C)
Features:
Parameter
Min. Typ. Max
Unit
• 950 – 2150 MHz
• 16 dB Isolation (output ports)
• Good Return Loss
• 0.8mm Height Profile
• 75Ω Outputs/Inputs
Frequency
Input Port Impedance
Output Port Impedance
Return Loss
950
2150
MHz
75
Ω
75
Ω
9.5
11
dB
• External resistors required
Insertion Loss*
0.8
1.0
dB
• Low Insertion Loss
• Surface Mountable
• Tape & Reel
• Non-conductive Surface
• RoHS Compliant
Amplitude Balance
Phase Balance
Isolation (Output Ports)
Power Handling
0.4
0.7
dB
2
3
Degrees
14
16
dB
2
Watts
Operating Temperature
-55
+85
ºC
* Insertion Loss stated at room temperature (Insertion Loss is approximately 0.1 dB higher at +85 ºC)
Outline Drawing
Top View (Near-side)
Side View
Bottom View (Far-side)
.079±.004
[2.00±0.10]
.033±.002
[0.84±0.05]
.049±.004
[1.25±0.10]
Orientation
Marker Denotes
Pin Location
Dimensions are in Inches [Millimeters]
Mechanical Outline
Pin Designation
1 Output 1
2 Input
3 Mid 2
4 Mid 1
5 GND
6 Output 2
.039
[0.98]
12
Orientation
Marker Denotes
Pin Location
65
6X .012
[0.30]
2X .026
[0.65]
3
6X .009
[0.22]
4
Tolerances are Non-Cumulative
Available on Tape
and Reel for Pick and
Place Manufacturing.
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]