B0430J50100A00 Datasheet, PDF (3/4 Pages) Anaren Microwave – Ultra Low Profile 0805 Balun

Model B0430J50100A00
Rev D
Mounting Configuration:
This component requires a 0603 10 pF capacitor to be mounted in front of the unbalanced port (Pin 2) of the balun
as shown in the drawing below for optimum performance. The capacitor should be placed as close as possible to the
balun to minimize transmission line effects as shown in the suggested PCB footprint below.
Note however, that in specific designs, the transmission line widths need to be adjusted to the unique dielectric
coefficients and thicknesses as well as varying pick and place equipment tolerances. In order for Xinger surface mount
components to work optimally, the proper impedance transmission lines must be used to connect to the RF ports. If
this condition is not satisfied, insertion loss, Isolation and VSWR may not meet published specifications.
All of the Xinger components are constructed from ceramic filled PTFE composites which possess excellent electrical
and mechanical stability having X and Y thermal coefficient of expansion (CTE) of 17 ppm/^oC.
Mounting Footprint
6X .012
[0.30]
6X .010
[0.25]
6X .002
[0.05]
3X Transmission
Line
Circuit Pattern
Footprint Pad (s)
Solder Resist
C1
Plated thru
holes to
ground
Part Orientation (Top View)
.033
[0.85]
4X .014
[0.35]
Available on Tape
and Reel for Pick and
Place Manufacturing.
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]