B0430J50100A00 Datasheet, PDF (1/4 Pages) Anaren Microwave – Ultra Low Profile 0805 Balun

Model B0430J50100A00
Rev D
Ultra Low Profile 0805 Balun
50Ω to 100Ω Balanced
Description
The B0430J50100A00 is a low cost, low profile sub-miniature unbalanced to
balanced transformer designed specifically for differential inputs and output
locations on next generation A to D and D to A Converter IC’s in an easy to use
surface mount package, covering 400 MHz–3000 MHz. The B0430J50100A00 is
ideal for high volume manufacturing and delivers higher performance than traditional
wire wound baluns. The B0430J50100A00 has an unbalanced port impedance of
50Ω and a 100Ω balanced port impedance. This transformation enables single
ended signals to be applied to differential ports. The output ports have equal
amplitude (-3dB) with 180 degree phase differential. The B0430J50100A00 is
available on tape and reel for pick and place high volume manufacturing.
Note that for optimal performance, the B0430J50100A00 should be used with a 10
pF series capacitor on the unbalanced port as shown in p. 2 & 3.
Detailed Electrical Specifications: Specifications subject to change without notice.
ROOM (25°C)
Features:
Parameter
Min. Typ. Max
Unit
• 400 – 3000 MHz
• 0.7mm Height Profile
• 50 Ohm to 2 x 50 Ohm
• Low Insertion Loss
• Designed for A-D and D-A
Converters
• Input to Output DC Isolation
• Surface Mountable
• Tape & Reel
• Non-conductive Surface
• RoHS Compliant
Frequency
Unbalanced Port Impedance
Balanced Port Impedance
Return Loss
Insertion Loss*
Amplitude Balance
Phase Balance
CMRR
Power Handling
400
3000
MHz
50
Ω
100
Ω
8.4
9.9
dB
3.4
4.0
dB
0.7
1.4
dB
7
12
Degrees
25
dB
1
Watts
Operating Temperature
-55
* Insertion Loss stated at room temperature (Insertion Loss is approximately 0.1 dB higher at +85 ºC)
Outline Drawing
+85
ºC
Top View (Near-side)
Side View
Bottom View (Far-side)
.079±.004
[2.00±0.10]
.027±.002
[0.70±0.05]
.049±.004
[1.25±0.10]
.039 [0.98]
12
.026 [0.65]
3
6X .009
[0.22]
Orientation
Marker Denotes
Pin Location
Dimensions are in Inches [Millimeters]
Mechanical Outline
Orientation
Marker Denotes 6 5
4
Pin Location _{6X .012}
Pin Designation
[0.30]
1 GND
2 Unbalanced Port
3 GND
4 Balanced Port
5 NC
6 Balanced Port
Tolerances are Non-Cumulative
Available on Tape
and Reel for Pick and
Place Manufacturing.
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]