X2AS_10 Datasheet, PDF (2/4 Pages) Anaren Microwave – SMT Crossover

Model X2AS
Rev C
Insertion Loss and Power Derating Curves
0
-0.02
-0.04
-0.06
-0.08
-0.1
-0.12
-0.14
-0.16
-0.18
-0.2
-100
Typical Insertion Loss Derating Curve for X2AS
typical insertion loss (f=2.5Ghz)
typical insertion loss (f=3.5Ghz)
typical insertion loss (f=6Ghz)
-50
0
50
100
150
200
Temperature of the Part (^oC)
50
45
40
35
30
25
20
15
10
5
0
0
X2AS Power Derating Curve
DC - 2.5
2.5 - 3.5
3.5 - 6.0
50
85 ₁₀₀
150
200
Mounting Interface Temperature (^oC)
Insertion Loss Derating:
Power Derating:
The insertion loss, at a given frequency, of a group of
couplers is measured at 25°C and then averaged. The
measurements are performed under small signal
conditions (i.e. using a Vector Network Analyzer). The
process is repeated at 85°C and 150°C. A best-fit line
for the measured data is computed and then plotted
from -55°C to 150°C.
The power handling and corresponding power derating
plots are a function of the thermal resistance, mounting
surface temperature (base plate temperature),
maximum continuous operating temperature of the
coupler, and the thermal insertion loss. The thermal
insertion loss is defined in the Power Handling section of
the data sheet.
As the mounting interface temperature approaches the
maximum continuous operating temperature, the power
handling decreases to zero.
If mounting temperature is greater than 95°C, Xinger
crossover will perform reliably as long as the input
power is derated to the curve above.
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]
Available on Tape and
Reel for Pick and Place
Manufacturing.